The 30' SRB was self-righting and self baling and designed with marked differences from the typical lifeboats used by the Coast Guard up until the early 1980s. The 30' SRB is not considered to be a Motor Lifeboat (MLB), but was generally used in a similar capacity. Designed to perform
search and rescue in adverse weather and surf the first 30' SRB was built by the Willard Boat Company in
Fountain Valley,
California. Much of the 30 footer's design centered on speed. The sides of the hull are made of 5/8" Airex foam cored
fiberglass reinforced plastic (FRP), and the bottom of the hull is constructed of solid FRP molded in one piece. The boat is 30' 4" in length with a 9' 4" beam, and weighs a total of when fully loaded with gear and engine. The 30 footer has a single
Detroit Diesel 6V92TI engine, configured by Johnson Towers rated at . The throttles are manually controlled, and the boat has a single screw and rudder. The 30' SRB's were rated for a top speed of although most of the hulls fell prey to minor water intrusion into the FRP, which slowed most of the boats to around at max RPM. The 30 footer has a range of , and most standard operating procedures dictate that the boat not go more than offshore without a waiver granted from higher level commands. The fuel capacity is 78 gallons at 100%, and the vessel is generally operated with a crew of two, a surfman and an engineer. The crew both stand on the
coxswain flat, protected by the
superstructure on the bow and stern. The boat's appearance has caused many to comment that it looks like a "Nike Tennis Shoe". ==Uses==