Aquifer

The word aquifer is derived from the latin prefix , the combining form of meaning "water," and suffix , meaning "bearing." == Properties ==

Depth (typical in humid regions). The water table and unsaturated zone are also illustrated.|upright=1.6 Aquifers occur from near-surface to deeper than . Those closer to the surface are not only more likely to be used for water supply and irrigation, but are also more likely to be replenished by local rainfall. Although aquifers are sometimes characterized as "underground rivers or lakes," they are actually porous rock saturated with water. Many desert areas have limestone hills or mountains within them or close to them that can be exploited as groundwater resources. Part of the Atlas Mountains in North Africa, the Lebanon and Anti-Lebanon ranges between Syria and Lebanon, the Jebel Akhdar in Oman, parts of the Sierra Nevada and neighboring ranges in the United States' Southwest, have shallow aquifers that are exploited for their water. Overexploitation can lead to the exceeding of the practical sustained yield; i.e., more water is taken out than can be replenished. Along the coastlines of certain countries, such as Libya and Israel, increased water usage associated with population growth has caused a lowering of the water table and the subsequent contamination of the groundwater with saltwater from the sea. In 2013 large aquifers containing offshore freshened groundwater were discovered under continental shelves of Australia, China, North America and South Africa. They contain an estimated half a million cubic kilometers of "low salinity" water that could be economically processed into potable water. The reserves formed when ocean levels were lower and rainwater made its way into the ground in land areas that were not submerged until the ice age ended 20,000 years ago. The volume is estimated to be 100 times the amount of water extracted from other aquifers since 1900. Groundwater recharge == Classification ==

An aquitard is a zone within the Earth that restricts the flow of groundwater from one aquifer to another. An aquitard can sometimes, if completely impermeable, be called an aquiclude or aquifuge. Aquitards are composed of layers of either clay or non-porous rock with low hydraulic conductivity. Saturated versus unsaturated Groundwater can be found at nearly every point in the Earth's shallow subsurface to some degree, although aquifers do not necessarily contain fresh water. The Earth's crust can be divided into two regions: the saturated zone or phreatic zone (e.g., aquifers, aquitards, etc.), where all available spaces are filled with water, and the unsaturated zone (also called the vadose zone), where there are still pockets of air that contain some water, but can be filled with more water. Saturated means the pressure head of the water is greater than atmospheric pressure (it has a gauge pressure > 0). The definition of the water table is the surface where the pressure head is equal to atmospheric pressure (where gauge pressure = 0). Unsaturated conditions occur above the water table where the pressure head is negative (absolute pressure can never be negative, but gauge pressure can) and the water that incompletely fills the pores of the aquifer material is under suction. The water content in the unsaturated zone is held in place by surface adhesive forces and it rises above the water table (the zero-gauge-pressure isobar) by capillary action to saturate a small zone above the phreatic surface (the capillary fringe) at less than atmospheric pressure. This is termed tension saturation and is not the same as saturation on a water-content basis. Water content in a capillary fringe decreases with increasing distance from the phreatic surface. The capillary head depends on soil pore size. In sandy soils with larger pores, the head will be less than in clay soils with very small pores. The normal capillary rise in a clayey soil is less than but can range between . The capillary rise of water in a small-diameter tube involves the same physical process. The water table is the level to which water will rise in a large-diameter pipe (e.g., a well) that goes down into the aquifer and is open to the atmosphere. Aquifers versus aquitards Aquifers are typically saturated regions of the subsurface that produce an economically feasible quantity of water to a well or spring (e.g., sand and gravel or fractured bedrock often make good aquifer materials). An aquitard is a zone within the Earth that restricts the flow of groundwater from one aquifer to another. A completely impermeable aquitard is called an aquiclude or aquifuge. Aquitards contain layers of either clay or non-porous rock with low hydraulic conductivity. In mountainous areas especially near rivers, the main aquifers are typically unconsolidated alluvium, that is horizontal layers of materials deposited by water processes such as rivers and streams. In cross-section, they appear as layers of alternating coarse and fine materials. Coarse materials, because of the high energy needed to move them, tend to be found nearer to their source, such as mountain fronts or rivers, whereas the fine-grained material travels farther, to the flatter parts of the basin or overbank areas—sometimes called the pressure area. Since there are less fine-grained deposits near the source, those aquifers, also known as the fore-bay area, are often unconfined or in hydraulic communication with the land surface. Confined versus unconfined An unconfined aquifer has no impermeable barrier immediately above it, such that the water level can rise in response to recharge. A confined aquifer has an overlying impermeable barrier that prevents the water level in the aquifer from rising any higher. An aquifer in the same geologic unit may be confined in one area and unconfined in another. Unconfined aquifers are sometimes also called water table or phreatic aquifers, because their upper boundary is the water table or phreatic surface (see Biscayne Aquifer). Typically (but not always) the shallowest aquifer at a given location is unconfined, meaning it does not have a confining layer (an aquitard or aquiclude) between it and the surface. The term "perched" refers to ground water accumulating above a low-permeability unit or strata, such as a clay layer. This term is generally used to refer to a small local area of ground water that occurs at an elevation higher than a regionally extensive aquifer. The difference between perched and unconfined aquifers is their size (perched is smaller). Confined aquifers are aquifers that are overlain by a confining layer, often made up of clay. The confining layer might offer some protection from surface contamination. If the distinction between confined and unconfined is not clear geologically (i.e., if it is not known if a clear confining layer exists, or if the geology is more complex, e.g., a fractured bedrock aquifer), the value of storativity returned from an aquifer test can be used to determine it (although aquifer tests in unconfined aquifers should be interpreted differently than confined ones). Confined aquifers have very low storativity values (much less than 0.01, and as little as ), which means that the aquifer is storing water using the mechanisms of aquifer matrix expansion and the compressibility of water, which typically are both quite small quantities. Unconfined aquifers have storativities (typically called specific yield) greater than 0.01 (1% of bulk volume); they release water from storage by the mechanism of actually draining the pores of the aquifer, releasing relatively large amounts of water (up to the drainable porosity of the aquifer material, or the minimum volumetric water content). Isotropic versus anisotropic In isotropic aquifers or aquifer layers the hydraulic conductivity (K) is equal for flow in all directions, while in anisotropic conditions it differs, notably in horizontal (Kh) and vertical (Kv) sense. Semi-confined aquifers with one or more aquitards work as an anisotropic system, even when the separate layers are isotropic, because the compound Kh and Kv values are different (see hydraulic transmissivity and hydraulic resistance). When calculating flow to drains or flow to wells in an aquifer, the anisotropy is to be taken into account lest the resulting design of the drainage system may be faulty. Porous, karst, or fractured To properly manage an aquifer its properties must be understood. Many properties must be known to predict how an aquifer will respond to rainfall, drought, pumping, and contamination. Considerations include where and how much water enters the groundwater from rainfall and snowmelt, how fast and in what direction the groundwater travels, and how much water leaves the ground as springs. Computer models can be used to test how accurately the understanding of the aquifer properties matches the actual aquifer performance. Environmental regulations require sites with potential sources of contamination to demonstrate that the hydrology has been characterized. Sandy deposits formed in shallow marine environments and in windblown sand dune environments have moderate to high permeability while sandy deposits formed in river environments have low to moderate permeability. as illustrated by the water slowly seeping from sandstone in the accompanying image to the left. Porosity is important, but, alone, it does not determine a rock's ability to act as an aquifer. Areas of the Deccan Traps, a basaltic lava formation in west-central India, are examples of rock formations with high porosity but low permeability, making them poor aquifers. Similarly, the micro-porous (Upper Cretaceous) Chalk Group of south east England, although having a reasonably high porosity, has a low grain-to-grain permeability, with its good water-yielding characteristics mostly due to micro-fracturing and fissuring. Karst . Karst aquifers typically develop in limestone. Surface water containing natural carbonic acid moves down into small fissures in limestone. This carbonic acid gradually dissolves limestone thereby enlarging the fissures. The enlarged fissures allow a larger quantity of water to enter which leads to a progressive enlargement of openings. Abundant small openings store a large quantity of water. The larger openings form a conduit system that drains the aquifer to springs. Characterization of karst aquifers requires field exploration to locate sinkholes, swallets, sinking streams, and springs in addition to studying geological maps. Conventional hydrogeologic methods such as aquifer tests and potentiometric mapping are insufficient to characterize the complexity of karst aquifers. These conventional investigation methods need to be supplemented with dye traces, measurement of spring discharges, and analysis of water chemistry. U.S. Geological Survey dye tracing has determined that conventional groundwater models that assume a uniform distribution of porosity are not applicable for karst aquifers. Linear alignment of surface features such as straight stream segments and sinkholes develop along fracture traces. Locating a well in a fracture trace or intersection of fracture traces increases the likelihood to encounter good water production. Voids in karst aquifers can be large enough to cause destructive collapse or subsidence of the ground surface that can initiate a catastrophic release of contaminants. The rapid groundwater flow rates make karst aquifers much more sensitive to groundwater contamination than porous aquifers. == Human use of groundwater ==

Challenges for using groundwater include: overdrafting (extracting groundwater beyond the equilibrium yield of the aquifer), groundwater-related subsidence of land, groundwater becoming saline, and groundwater pollution. == By country or continent ==

found in Edwards Aquifer Africa Aquifer depletion is a problem in some areas, especially in northern Africa, where one example is the Great Manmade River project of Libya. However, new methods of groundwater management such as artificial recharge and injection of surface waters during seasonal wet periods has extended the life of many freshwater aquifers, especially in the United States. Australia The Great Artesian Basin situated in Australia is arguably the largest groundwater aquifer in the world (over ). It plays a large part in water supplies for Queensland, some remote parts of South Australia and most of the Northern Territory. Canada Discontinuous sand bodies at the base of the McMurray Formation in the Athabasca Oil Sands region of northeastern Alberta, Canada, are commonly referred to as the Basal Water Sand (BWS) aquifers. Saturated with water, they are confined beneath impermeable bitumen-saturated sands that are exploited to recover bitumen for synthetic crude oil production. Where they are deep-lying and recharge occurs from underlying Devonian formations they are saline, and where they are shallow and recharged by surface water they are non-saline. The BWS typically pose problems for the recovery of bitumen, whether by open-pit mining or by in situ methods such as steam-assisted gravity drainage (SAGD), and in some areas they are targets for waste-water injection. South America The Guarani Aquifer, located beneath the surface of Argentina, Brazil, Paraguay, and Uruguay, is one of the world's largest aquifer systems and is an important source of fresh water. Named after the Guarani people, it covers , with a volume of about , a thickness of between and a maximum depth of about . United States The Ogallala Aquifer of the central United States is one of the world's great aquifers, but in places it is being rapidly depleted by growing municipal use, and continuing agricultural use. This huge aquifer, which underlies portions of eight states, contains primarily fossil water from the time of the last glaciation. Annual recharge, in the more arid parts of the aquifer, is estimated to total only about 10 percent of annual withdrawals. According to a 2013 report by the United States Geological Survey (USGS), the depletion between 2001 and 2008, inclusive, is about 32 percent of the cumulative depletion during the entire 20th century. In the United States, the biggest users of water from aquifers include agricultural irrigation and oil and coal extraction. "Cumulative total groundwater depletion in the United States accelerated in the late 1940s and continued at an almost steady linear rate through the end of the century. In addition to widely recognized environmental consequences, groundwater depletion also adversely impacts the long-term sustainability of groundwater supplies to help meet the Nation’s water needs." in central Texas. This carbonate aquifer has historically been providing high quality water for nearly 2 million people, and even today, is full because of tremendous recharge from a number of area streams, rivers and lakes. The primary risk to this resource is human development over the recharge areas. == See also ==