Balloon modelling

The origins of balloon modelling are unknown. The 1975 book by "Jolly the Clown" Art Petri credits "Herman Bonnert from Pennsylvania at a magician's convention in 1939" as being the first balloontwister. Val Andrews, in Manual of Balloon Modeling, Vol. 1, An Encyclopedic Series, credits H.J. Bonnert of Scranton, Pennsylvania as being the "daddy of them all". Jim Church III states, "Frank Zacone from Youngstown, Ohio was doing a balloon act during the 1940s and had been doing the act for some time." ==Equipment==

wearing a balloon hat in 2015 Modellers will use an assortment of balloons, usually in various colors. Balloon sizes are usually identified by a number: the most common size of twisting balloons is called a "260", as it is approximately two inches in diameter and 60 inches long. Thus, a "260" is 2×60 inches and a "160" is 1×60 inches when fully blown up. Although these are the most common sizes used, there are dozens of other shapes available as well. The most common methods for inflation are air pumps similar to bicycle pumps, electric air compressors, and the mouth. Inflating a balloon with the mouth is difficult and can be dangerous. Particularly well-trained and talented twisters, however, can blow-up several balloons at once, and some can even blow up 160s, which are much more difficult to mouth-inflate than the more common 260s, as their narrowness requires a great deal more strength and breath pressure to inflate. ==See also==