Construction and independent operation A "Bristol and South Wales Junction Railway" was authorised by an
act of Parliament, the '
(9 & 10 Vict. c. cv). Isambard Kingdom Brunel surveyed a route across the Severn and the ferry at New Passage was purchased, but the line failed to raise enough money so was not built. The "Bristol, South Wales and Southampton Union Railway" proposed in 1854 to carry a line through the centre of Bristol and along the Avon Gorge to New Passage, where a train ferry would cross the water. This became the "Bristol and South Wales Union Railway" (B&SWUR). The ' (
20 & 21 Vict. c. 54) was passed on 27 July 1857 authorising a route to the east and north of Bristol. Brunel died in 1859 and the works were completed by
Robert Pearson Brereton. Construction started in 1858 and the single-track
broad gauge line opened from South Wales Junction, half a mile east of
Temple Meads, as far as the landward end of New Passage
Pier on 8 September 1863, a distance of . The distance by rail between Bristol and Cardiff was reduced from to . Stations were opened at , , , , and . The short section on the opposite side of the Severn officially opened on 1 January 1864. On 13 August 1864 station was opened between Stapleton Road and Filton. In 1868 the was
amalgamated with the Great Western Railway (GWR) which had operated its trains from the outset.
Subsequent history Under ownership, the Portskewett branch was converted to
standard gauge on 13 May 1872 along with all the other broad gauge lines on that side of the river. The Bristol section was closed for one day on 8 August 1873 and reopened the following day as a standard gauge line. On 1 October 1874 a junction was put in at Narroways Hill, just north of
Stapleton Road railway station, to connect the with the
Clifton Extension Railway, a joint venture with the
Midland Railway to serve the affluent
Clifton district. The line from Temple Meads to Narroways Hill Junction was doubled at the same time. Work had started on the
Severn Tunnel a little way downstream from New Passage in 1872 and sidings were laid at both Portskewett and New Passage in connection with sinking shafts to the tunnel workings. On 29 May 1886 a curve was opened near South Wales Junction (between Dr Day's Junction and North Somerset Junction) to allow trains to run directly from London to the new Tunnel. The line between Narroways Hill Junction and Patchway was also doubled to carry the heavier traffic. Just short of
Pilning railway station the new route diverged to south and a new station was built. The ferry and Pilning-New Passage line ceased operation after 30 November 1886 and the tunnel opened for passenger trains the following day, although goods trains had already been using the new route. A new single track tunnel alongside the old tunnel at Almondsbury carried the Up line on a more gentle gradient from 1887. The increased traffic caused the line from Dr Day's Junction to Narroways Hill Junction to be widened to four tracks in 1891. The had been authorised to construct a line from Pilning to a proposed new dock at
Avonmouth in 1862, but neither the dock nor railway was built. The GWR reopened a section of the old line for goods traffic on 5 February 1900, this ran from Pilning to New Passage and then connected with a new route to
Avonmouth railway station. Passenger trains ran from Avonmouth as far as a new
Severn Beach railway station from 10 July 1922, and continued to new stations at New Passage and Pilning (known as "Pilning Low Level") from 9 July 1928. The service was withdrawn from 23 November 1964. ==Stations==