Chicago City Railway In 1900 the Chicago City Railway was the largest cable operator in the country. Incorporated on February 14, 1859, it was well managed and progressive from its beginning. In 1880 their president had inspected the successful San Francisco lines, and felt cable could be used in Chicago. In 1882 they opened the first cable lines outside of San Francisco. They then built lines past the built up areas, making land along the route more valuable. Development followed the lines, making more traffic. When first opened the State St. and Wabash - Cottage Grove Avenue lines both used a slow speed () three block loop. This could not handle the traffic, in 1892 the Cottage Grove Avenue line started using a new two block loop directly east of the original, which was rebuilt two years later. Trains of both lines ran opposite each other on Wabash Ave. Because CCR grip cars were bi-directional, trains could be reversed onto the opposite track, and did not need a loop. It also meant that a train could stop and return without going to the end of the line. The Cottage Grove line had runs reversing at 39th St. and at the end of the line. In 1887 the CCR carried 70,000 to 100,000 passengers a day on approximately 150 trains. By 1892, after both lines had been lengthened, 300 trains were scheduled daily. Three powerhouses pulled thirteen cables. In 1906 CCR electrified its State St. line on July 22, and the Wabash-Cottage Grove Ave. line on October 21, the last day of cable service in Chicago. On February 1, 1914, the CCR began operating as part of the
Chicago Surface Lines (CSL).
North Chicago Street Railroad The North Chicago Street Railroad was the smallest of the three companies. Incorporated in 1859 as the North Chicago Street Railway, a horse-car system, it was badly damaged by the
Great Chicago Fire of 1871. Little improvement was done until 1885, when a Philadelphia syndicate controlled by Charles Tyson Yerkes reorganized it as the North Chicago Street Railroad. In 1886 it began converting to cable. All the NCSR's lines entered downtown through the
LaSalle St. tunnel and used a six block loop. The Clybourn Ave. line was the only place where single combination cars were used. The end of that route at had a turntable, rather than the loops that the other lines used. The NCSR had up to 177 grip cars and many more trailers. Three powerhouses pulled 9 cables. On May 24, 1899, the NCSR and WCSR were combined into the Chicago Union Traction Co., which would go into receivership on April 22, 1903 and was bought by the Chicago Railway Co. (CR) on January 25, 1908. On February 1, 1914, the Chicago Railway Co. began operating as part of the Chicago Surface Lines.
West Chicago Street Railroad The West Chicago Street Railroad was incorporated in 1861 as the Chicago West Division Railway, in 1885 the Chicago Passenger Railway opened as a competitor. In 1887 the two were combined and reorganized by Charles Tyson Yerkes as the West Chicago Street Railroad. This put the NCSR. and WCSR under the same ownership, it began cable service in 1890, the last of the three companies to do so. A northwest and west line used another
tunnel under the river on Washington St. to get to a two block loop, a four block loop was later added. A south and southwest line terminated west of the river until the privately built Van Buren St. tunnel opened in 1894, an eight block loop was used. The northwest Milwaukee Ave. line used single combination cars, all other lines used short grip cars with trailers. The WCSR had 230 grip cars and several times many trailers. Six powerhouses pulled 12 cables. On May 24, 1899 the WCSR, like the NCSR, was combined into the CUT, which would be bought by the CR on January 25, 1908. On February 1, 1914, the CR began operating as part of the Chicago Surface Lines. ==Remnants==