Natural waterfalls are commonly formed in the upper course of a river where lakes flow into valleys in steep mountains. A river sometimes flows over a large step in the rocks that may have been formed by a
fault line. Waterfalls can occur along the edge of a
glacial trough, where a stream or river flowing into a
glacier continues to flow into a valley after the
glacier has receded or melted. The large waterfalls in
Yosemite Valley are examples of this phenomenon, which is referred to as a
hanging valley. Another reason hanging valleys may form is where two rivers join and one is flowing faster than the other. A waterfall is usually defined as being at least five feet high, although most are higher.
Mill Pond Falls, in
Newington, Connecticut, high, is claimed to be the smallest natural waterfall in the United States. Some sources use a minimum height of . A glossary of waterfall terms was published in 1996. There are many different types of waterfalls. • Combination: • Cascade: • Cataract • Ledge • Block / Sheet • Classical • Curtain • Overhanging Ledge • Plunge / Vertical • Punchbowl • Chute • Fan • Horsetail • Parallel / Twin • Ribbon • Scree / Talus • Segmented • Slide • Slot / Keyhole • Tiered / Staircase / Multi-Stepped • Veil • Frozen • Dry / Historic
Caprock model The caprock model of waterfall formation states that the river courses over resistant
bedrock, erosion happens slowly and is dominated by impacts of water-borne sediment on the rock, while downstream the erosion occurs more rapidly. As the watercourse increases its velocity at the edge of the waterfall, it may pluck material from the riverbed, if the bed is fractured or otherwise more erodible. Hydraulic jets and hydraulic jumps at the toe of a falls can generate large forces to erode the bed, especially when forces are amplified by water-borne sediment. Horseshoe-shaped falls focus the erosion to a central point, also enhancing riverbed change below a waterfall. A process known as "potholing" involves local erosion of a potentially deep hole in bedrock due to turbulent
whirlpools spinning stones around on the bed, drilling it out. Sand and stones carried by the watercourse therefore increase erosion capacity. The rate of retreat for a waterfall can be as high as one-and-a-half metres per year. Waterfalls normally form in a rocky area due to erosion. After a long period of being fully formed, the water falling off the ledge will retreat, causing a horizontal pit parallel to the waterfall wall. Eventually, as the pit grows deeper, the waterfall collapses to be replaced by a steeply sloping stretch of river bed. In addition to gradual processes such as erosion, earth movement caused by
earthquakes or
landslides or
volcanoes can lead to the formation of waterfalls. == Ecology ==