Sidevalve engines In a
flathead (
sidevalve) engine, all of the
valvetrain components are
contained within the block, therefore the head is usually a simple plate of metal bolted to the top of the
engine block. Sidevalve engines were once universal but are now largely obsolete in automobiles, found almost exclusively in small engines such as lawnmowers, weed trimmers and chainsaws.
Intake over exhaust (IOE) engines Intake Over Exhaust (IOE) engines combined elements of the sidevalve and overhead valve designs. Used extensively in American motorcycles in the early 1900s, the IOE engine remained in production in limited numbers until the 1990s. IOE engines are more efficient than sidevalve engines, but also more complex, larger and more expensive to manufacture.
Overhead engines (OHV & OHC) In an
overhead valve (OHV) or
overhead camshaft (OHC) engine, the cylinder head contains several airflow passages called
ports; intake ports deliver the fuel+air intake charge from the
intake manifold to the
combustion chamber, and exhaust ports route combustion waste gases out the combustion chamber to the
exhaust manifold.
Valves open and close the ports, with the intakes offset fore-and-aft from the exhausts. The head also contains the
spark plugs, and on
water-cooled engines, the coolant passages.
Overhead valve (OHV) engines A single
camshaft located in the engine block uses
pushrods and
rocker arms to actuate all the valves. OHV engines are typically more compact than equivalent OHC engines, and fewer parts mean cheaper production, but they have largely been replaced by OHC designs, except in some American V8 engines.
Overhead camshaft (OHC) engines An
overhead camshaft (OHC) engine locates the camshaft(s) in the cylinder head above the combustion chamber. Eliminating pushrods lessens valvetrain inertia and provides space for optimized port designs, both providing increased power potential. In a
single overhead camshaft (SOHC) engine, the camshaft may be seated centrally between valve rows, or directly above a single row of valves (replacing rocker arm actuation with
tappets). SOHC engines were widely from the 1960s to 1990s. (eliminating pushrods but still utilizing rocker arms)
Double overhead camshaft (DOHC) engines seat a camshaft directly above each row of offset valves (intakes inboard, exhausts outboard). DOHC designs allow optimal
crossflow positioning of valves to provide higher-
RPM operation. They are typically larger in size (especially width) than equivalent OHV or SOHC engines. Even though more components raise production costs, DOHC engines seen widespread use in automobile engines since the 1990s. ==Gallery==