Dinosterol

Dinosterol is a C30 sterol characterized by four fused rings (three six-membered and one five-membered), seven methyl groups, an olefin in its side-chain, and a secondary alcohol. The double bond in the side chain is located at the 22 position, and dinosterol's methyl groups are at the 20, 23, 24 and 25 positions of the side chain. The structure of dinosterol is established as 4α,23,24-trimethyl-5α-cholest-22-en-3β-ol. Dinosterol contains an unusual pattern of side-chain alkylation with methyl groups at C-23 and C-24. This substitution motif was thought to be unique to dinoflagellate sterols, until Volkman et al. (1993) found a diatom belonging to the genus Navicula, which contains several 4-methyl sterols including dinosterol. == Biosynthesis ==

4-Methyl sterols are intermediates in the biosynthesis of 4-desmethyl sterols and are known to accumulate under anaerobic conditions. The sequence of side-chain alkylations is thought to be initiated by the formation of 4α,24-dimethyl-5α-cholest-24(28)-en-3β-ol, followed by reduction to 4α,24-dimethyl-5α-cholestan-3β-ol, then introduction of the Δ22-double bond to form 4α,24-dimethyl-5α-cholest-22E-en-3β-ol and then methylation at C-23 to form 4α23,24-trimethyl- 5α-cholest-22E-en-3β-ol (dinosterol). This mechanism has been previously reported in fungi, a chrysophyte alga and a diatom. Importantly, no deuterium was incorporated into cholesterol or cholesta-5,7-dien-3β-ol, which are the major 4-methyl-sterols in Crypthecodinium cohnii. A suggested biosynthetic mechanism for side chain alkylations at C-23 and C-24 in dinosterol has been proposed.|center|326x326px == Biological occurrence ==

Dinoflagellates are the primary source of dinosteral. Dinoflagellates are unicellular, aquatic organisms that live in both marine and inland environments and are a prominent constituent of phytoplankton. Dinoflagellates are often characterized by their uncommon sterol distribution, dominated by 4α-methyl sterols derived from lanosterol rather than cycloartenol. Dinosterol is often used a biomarker in geochemical research because it is produced almost exclusively by dinoflagellates and is found in many environments. In addition to several species of dinoflagellates, dinosterol has also been isolated from the diatom Nivicula sp. (CS-46c) collected from Port Hacking, New South Wales, Australia. == Preservation and diagenesis ==

Steroids are often preserved in petroleum as saturated and aromatic steroidal hydrocarbons that result from transformations occurring during diagenesis. After senescence of steroids from aquatic producers, they undergo rapid re-mineralization under aerobic conditions in the upper water column. A small percentage of the intact sterols produced in the euphotic zone endure diagenesis, where microbial mediated transformations effectively yield compounds that can then be related back to their parent sterols and are more stable in the geologic record. The preservation of sterols is often limited, but is enhanced by anaerobic conditions during their deposition and subsequent diagenesis, in particular, early sulfurization and reduction mediated by sulfur species. Intact dinosterol has been reported from sediments of the presumed late Jurassic age, possibly due to incomplete degradation of lipids in the water column under high productivity conditions in the presence of sulfate reducers. These transformations are controlled by microbial activity and low temperature physiochemical reactions. Thermodynamically driven abiotic physicochemical reactions further alter the steroids by causing complete aromatization, isomerization and cracking of the steroids. These more stable compounds co-exist with their precursor sterols and their intermediate diagenetic products can only occur in immature sediments when incomplete microbial degradation has occurred. == Measurement techniques ==

Standard organic geochemical methods are employed to prepare samples of dinosterol for analysis. Collected algae samples can be centrifuged and then lyophilized. Other purification techniques for dinosterol include various combinations of thin layer (TLC) and column chromatography with a variety of phases, AgNO3 impregnated Silica gel chromatography, normal phase-high performance liquid chromatography (NP-HPLC), and reversed phase-high performance liquid chromatography (RP-HPL).|292x292pxAn alternative method has been proposed for purifying dinosterol from complex mixtures of sedimentary lipids for the purpose of hydrogen isotope analysis via gas chromatography-isotope ratio mass spectrometry (GC-IRMS). Reversed phase-high performance liquid chromatography (RP-HPLC) is used to separate dinosterol from structurally similar 4α-methyl sterols that co-elute on GC analysis, which allows for baseline resolution of dinosterol. For samples that contain a variety of 4a-methyl sterols, RP-HPLC purification can be preceded by NP-HPLC purification. == Use as a biomarker ==

Dinosterol is used as a biomarker for organic matter derived from dinoflagellates in sediments and seawater. Biomarkers are organic compounds that are indicative of former life in sediments, seawater and oil. The presence of the saturated hydrocarbon counterpart, dinosterane, is used as evidence that some of the organic matter present in ancient sediments may have been derived from dinoflagellates. Dinosterol has been used as an indicator for dinoflagellate production in the Cariaco Basin. In such studies, it has been revealed that the accumulation of dinosterol peaks at a rate of almost 900 mg compound/cm2/yr during the Younger Dryas. Some studies have revealed that certain dinoflagellates produce sterols that have the potential to serve as genera-specific biomarkers. Recent work showed that dinoflagellate genera, which formed discrete clusters in the 18S rDNA-based phylogeny, shared similar sterol compositions. This suggested that the sterol compositions of dinoflagellates are explained by the evolutionary history of this lineage. Dinosterol in a Marine Diatom In 1992, Volkman et al. reported the first evidence of dinosterol in a laboratory culture of a marine diatom Navicula sp., indicating that diatoms may be a source of dinosterol in marine sediments. Dinosterol has been used as a biomarker for dinoflagellates whose sedimentary concentration has been correlated with changes in marine production rates. In a study by Schubert et al., it was shown that dinosterol has a concordant concentration maximum that coincides with organic carbon maxima over the past 200,000 years in a sediment core from the northeastern Arabian Sea. In this study, dinosterol was used to trace changes in ocean production in the Arabian Sea. Due to similar distributions of dinosterol and brassicasterol, a biomarker indicative of diatom abundances, it was concluded that the relative contributions of the dominant members of the phytoplankton community to production were uniform on timescales greater than 3,000–4,000 years over the past 200,000 years, despite overall paleoproduction having changed dramatically. In a study by Belicka et al., six sediment cores from two shelf-basin transects in the Chukchi and Beaufort Seas of the Arctic Ocean were examined in order to compare the sources and preservation of organic carbon between the two differing depositional regimes. This study found an unexpected correlation between dinosterol and α-amyrin, which is found in terrestrial plants, in shelf and slope sediments, in particular the Beaufort Shelf, suggesting that dinoflagellates contribute significantly to phytoplankton abundance in areas of seasonal open water. Hydrogen isotope analysis requires a purification method that achieves GC baseline resolution and is high yielding. Dinosterol coelutes with other sterols during GC; therefore a procedure for proper purification that involves reversed phase-high performance liquid chromatography (RP-HPLC) was developed by Atwood et al. The D/H ratio was found to decrease by 0.99 ± 0.23% per unit increase in salinity over the salinity range 10–29 PSU. The correlation between hydrogen isotopic response and salinity may result from diminished exchange of water between algal cells and their environment, lower growth rates and/or increased production of osmolytes at high salinities. ==References==