Since the 1960s,
integrated circuits make construction of DIY audio systems easier, but the proliferation of
surface mount components (which are small and sometimes difficult to solder with a
soldering iron) and fine pitch
printed circuit boards (PCBs) can make the physical act of construction more difficult. Nevertheless, surface mounting is often used, as are conventional PCBs and electronic components, while some enthusiasts insist on using old-style perforated cardboard onto which individual components are hardwired and soldered.
Test equipment is readily available for purchase and enables convenient testing of parts and systems. Specifications of parts and components are readily accessible through the Internet including data sheets and equipment designs. It has become easier to make audio components from scratch rather than from kits due to the availability of
CAD software for
printed circuit board (PCB) layouts and electronic circuit
simulation. Such software can be free, and a trial version may also be used. PCB vendors are more accessible than ever, and can manufacture PCBs in small quantities for the do-it-yourselfer. In fact, kits and chemicals for self-manufacturing one's own PCB can be obtained. Electronic parts and components are accessible online or in speciality shops, and various high-end parts vendors exist. On the other hand, a wide variety of kits, designs and premanufactured PCBs are available for almost any type of audio component. To construct a device takes more than knowledge of
circuits, many would urge that the mechanical aspects of cabinets, cases and chassis' are the most time consuming aspects of audio DIY.
Drilling,
metalworking and physical
measurements are critical to constructing almost any DIY audio project, especially speakers. Measuring equipment such as a
Vernier caliper is often essential. Woodworking skills are required to construct wooden enclosures (e.g. for speakers), with some enthusiasts going beyond traditional woodworking to
CNC turning, and luxurious
veneers and
lacquers. Room acoustics solutions are also popular among DIYers, as they can be made with inexpensive and readily available insulating materials, and can be dimensioned to fit each particular room in a precise and aesthetically pleasing way. DIY audio involves projects directed to audio. Many DIY audio people fancy themselves to be
audiophiles. These people use rare and expensive parts and components in their projects. Examples are the use of
silver wire, expensive
capacitors, non-standard
solders of various alloys, and use of parts that have been
cryogenically cooled.
Vacuum tube or valve projects are common in audio DIY. While, for mass market audio components, the vacuum tube has been replaced in modern times with the
transistor and IC, the vacuum tube remains prominent in specialty high end audio equipment. Thus, interest exists in building components using vacuum tubes, and the vacuum tube is still widely available. There is a wide variety of tubes manufactured nowadays, and many tubes on the market are advertised as
NOS; not all of the latter being genuinely NOS. Circuits utilizing tubes often are far less complicated than those utilizing transistors or op-amps. Tube enthusiasts often use transformers, sometimes custom-made ones, or even hand-wind their own transformers using cores and wire of their own choice. Note that vacuum tube projects almost always use
dangerously high voltages and should be undertaken with due care. In case
lead-containing solder is used instead of
RoHS-compliant solder, appropriate environmental precautions with regard to lead and lead products should be taken. ==Tweaking and tweakers==