| 103 E: | 103 E Familiare: }} | 103 E: | 103 E Familiare: }} }}
1953: 1100/103 The
Fiat Nuova 1100, or
Fiat 1100/103 as it was called after its internal project number, was introduced at the April
1953 Geneva Motor Show. Unlike the 1100 E it replaced, the 103 had a modern four-door saloon
pontoon body topping new
unibody construction, both pioneered in Fiat's range by the 1950
1400. If the 103's body was all-new, its engine was well-tested; the car's engine debuted in 1937 on the predecessor of the outgoing 1100 E, the
508 C Balilla 1100. Updated as type
103.000, the
overhead valve four-cylinder was fed by a single
Solex or
Weber downdraught
carburettor, and put out at 4,400 rpm—just one horsepower more than on the 1100 E. The Type A right hand drive export models were only available in black. They were also equipped with a heater and ventilation system as well. The Type A cars also came with slightly broader body trim strips compared to the Type B. On left hand drive versions of both the Type A and Type B cars, the dashboard contained a large plastic badge (on the right hand side) stating "Millecento" covering the orifice where a radio could be installed. However on the right hand drive cars, this badge which was located on the left hand side contained the wording Fiat 1100 on the Type A cars and Millecento on the Type B cars. The type B came in a choice of paint hues and interior fabrics, and could be ordered with factory-fitted
whitewall tyres and
radio. A distinguishing feature of 103s throughout the 1950s were the
doors, both hinged on the centre
pillar; The TV was fitted with an improved engine (type
103.006), which developed at 5,400 rpm rather than the of the regular versions, mainly thanks to a twin-choke Weber carburettor and a higher 7.4:1 (instead of 6.7:1)
compression ratio. Abroad, it was alternatively known as the 1100 Family, 1100 Familiale, 1100 Kombiwagen, or 1100 Familiar in English-, French- German-, and Spanish-speaking markets respectively. The rear door was side-hinged, and the vinyl-covered rear bench could be folded down to form a flat loading surface, able to carry a load of . A third row of two forward-facing jump seats allowed to carry a fifth and sixth passenger, folding level with the boot floor when not in use. As its name implied, it was based on mechanicals from the 1100 TV. Like the
Turismo Veloce saloon, the American-inspired design of the Trasformabile was the work of
Dipartimento Carrozzerie Derivate e Speciali, the special bodies department of Fiat, rather than of a third-party
coachbuilder; it was penned by the department's head, engineer and designer
Fabio Luigi Rapi. 571 of these first series Trasformabiles were built. In 1956 it received a more powerful engine (three more horsepower) and a modified rear suspension; 450 more of these were built. During 1957, a transitory model of the 1100TV Trasformabile was produced, featuring updated exterior styling but with an identical interior, for a short period before the introduction of the
1200 Trasformabile. These transition period cars are exceptionally rare, and were primarily destined for export markets. When the 1200 Trasformabile was released that same year, it was now equipped with the more powerful "1200" engine (1221 cc). Production of this model continued until 1959, with circa 2360 of the 1.2-litre Trasformabiles built. The design was first seen on a one-off displayed at the 1953
Paris Motor Show and entered by
Umberto Agnelli at a race event held in 1954 near Turin, the Orbassano 6 hours Cup. The new series bore the type code
103 E. All models—saloon type A and B, Familiare, TV and TV Trasformabile—were continued. The latter was an elegant saloon, developed from the 1100 designing a more modern bodyshell and enlarging the engine to 1.2 litres, and replaced the 1100 TV. Therefore, the 1100 range was left temporarily without an upmarket variant, and consisted of just two models: saloon and estate, both sporting contrasting colour roofs as standard. The saloon's new tail was longer and carried
tailfins. Boot space had increased, and the rear window had also been enlarged. On the other hand, the estate's sheetmetal was unchanged; body-colour buttresses were added to fit the new tail lights to the 1954-vintage body. Almost all of the exterior trim was new, including door handles and turn signal repeaters. The Special changed its name depending on the market—e.g. it was named Speciale in Italy and Spezial in Germany. The main difference between Special and Export saloons was the sheetmetal: the Export used a 103 H Lusso bodyshell, while the Special became the first 1100 with four front-hinged doors, as it adopted the more modern
1200 Granluce's bodyshell. Otherwise the two saloons had nearly identical interior trim and equipment. Both had been stripped of the Granluce and Lusso's glitzy trim and their complex paint schemes—though a contrast colour roof remained optional on the Special. These were nicknamed "millecento" and are specially loved by Italian descendants. Fiat 1100 Special in Ivory, front right (Brescia).jpg|Fiat 1100 Special; note the front-hinged doors 19 - Maastricht - 20149016 - RCE (cropped).jpg|Fiat 1100 Export File:Fiat 1100-103-Familiare.JPG|Fiat 1100/103 H Familiare
Indian production by PAL The Fiat 1100/103 was imported to
India and sold by
Premier Automobiles Limited (PAL). The older model was known as the Millecento and the one with the centre light (Chest light) on the front grille (1100/103 E) as the Elegant. In 1958, the 1100/103 D (tailfin model) was introduced as the Select. It was followed by the Super Select in 1961. By 1964, the 1100 D Delight was introduced and it was assembled in India by PAL. This model has most of the parts manufactured locally. In India it was considered a sportier alternative to the
Hindustan Ambassador. ==1100 D==