The manufacture of aeroplanes started in 1910, when
Sir George White, the owner of
Bristol Tramways, established the British and Colonial Aeroplane Company in the maintenance sheds of Bristol Tramways. A small 'flying ground' was set up opposite Fairlawn Avenue in 1911, at the top of Filton Hill.
First World War The company grew rapidly during the First World War, building thousands of
Bristol Fighters and other aircraft. In 1915, as the Aircraft Works expanded over the original flying area, the
Royal Flying Corps established Filton Airfield in fields at the bottom of Filton Hill. Access was via the hamlet of
Charlton. The hamlet was taken over by the
War Office, with people being re-housed and most of the houses demolished, though some survived up until the airfield was closed and the land readied for the Charlton Hayes housing estate. The First World War buildings on the military base were wooden huts, but eventually more permanent structures were erected, including Barnwell Hall. During the war, RFC Filton was mainly used as an aircraft acceptance facility. A flying school was located beside the airfield runway, and the site eventually became part of the Engine Division of the
Bristol Aeroplane Company.
Inter-war years , near London Aero-engine production started close to Filton Airfield, with the acquisition of
Cosmos Engineering in 1920. In the same year, the British and Colonial Aeroplane Company became the Bristol Aeroplane Company, often abbreviated to BAC. From 1929 the
No. 501 (City of Bristol) Squadron RAF was based at
RAF Filton. The squadron was equipped with
Hawker Hurricanes by 1939 and formed part of the British forces sent to France.
Second World War Before the Second World War, there were only grass runways at Filton. The
re-armament programme from 1935 to the outbreak of war saw further expansion of the Bristol Aeroplane Company, and East Works on Gypsy Patch Lane and Rodney Works along Gloucester Road North were established for the production of aircraft engines. Until the war, there was a belief that German bombers had insufficient range to reach Filton; however, the invasion of France by the Nazis in 1940 changed the situation. As war approached, anti-aircraft guns were set up in a field pasture on Filton Hill, next to Filton Golf Club, to defend the aircraft factories. On 25 September 1940, German aircraft, based in France, raided Filton, causing extensive damage to the aircraft factories, as well as heavy loss of life when several air-raid shelters were hit. In response, a squadron of
Supermarine Spitfires was based at Filton. Before
D-Day, US-manufactured aircraft were assembled at Filton Aerodrome, from assemblies imported via
Avonmouth docks. Filton became a major port-of-entry for US casualties after the D-Day landings in June 1944, most of them taken to
Frenchay Hospital. Aircraft produced at Filton during the war included the
Blenheim,
Beaufort,
Beaufighter and
Brigand. Filton Aerodrome was upgraded to a concrete runway during 1941/42.
Post war After the Second World War, the concrete runway at Filton Aerodrome was extended westwards by
John Laing & Son to enable the huge
Bristol Brabazon airliner to take off safely. This extension required demolition of the
hamlet of
Charlton; it also severed the pre-war Filton bypass. The three-bay Brabazon Aircraft Assembly Hall (AAH) was built in the late 1940s under the direction of
T. P. O'Sullivan. The hangar doors and the railway level crossing for the aircraft were the largest in the world at the time. After a worker was crushed and killed while taking a sleep in one of the folds of the hangar doors, a siren was installed to warn employees when the doors were being operated. During the late 1940s and early 1950s, BAC branched out into the development and production of pre-fabricated buildings, plastics, helicopters, guided weapons, luxury cars, gas turbines and ramjet motors. The
Bristol Britannia (Whispering Giant) airliner and
Bristol Freighter were produced. In 1948, 501 Squadron was equipped with
De Havilland Vampire jets. These were a common sight in the skies around Filton in the early to mid-1950s. 501 was disbanded on 3 February 1957. As a protest, one of the pilots flew his aircraft under the
Clifton Suspension Bridge, but he crashed into a hillside on the
Leigh Woods side of the
Avon Gorge, near
Sea Mills, Bristol, and was killed. During the late 1940s and early 1950,
British Overseas Airways Corporation (BOAC) flew their
Lockheed Constellations and
Boeing Stratocruisers into Filton to be serviced in the newly completed Brabazon Hangar, then the largest hangar in the world. Maintenance flights to Filton ceased when suitable hangars were completed at London
Heathrow Airport. In 1954, BAC opened a technical college for apprentices and trainees at the bottom of Filton Hill. This was eventually absorbed by
Filton Technical College, that had opened on the opposite side of Filton Avenue in 1961. In 1958, the aero engine interests of the Bristol Aeroplane Company and
Armstrong Siddeley were amalgamated to form
Bristol Siddeley Engines.
Rolls-Royce purchased Bristol Siddeley Engines in 1966. On 4 February 1971, Rolls-Royce were declared bankrupt due to the burden of development of the
RB211 engine for the
Lockheed L-1011 Tristar jetliner. Due to the importance of Rolls-Royce engine division to the Royal Air Force, the Government nationalised the company.
Frederick Corfield the then local MP, was then Minister for Aviation, and presumably had influence over what was an unusual decision for a Conservative administration. In 1960, the
British Aircraft Corporation took over the aircraft interests of the Bristol Aeroplane Company. In 1960 an RAF Vulcan bomber, approaching from the west, landed at Filton in heavy rain. The pilot braked, but started to aquaplane. He decided to abort the landing. Although he managed to take-off and eventually land successfully elsewhere, the jet blast from the aircraft's four Bristol Siddeley
Olympus 201 engines severely damaged a filling station at the eastern end of the runway, sent cars spinning on the A38 trunk road and wrecked the boundary fence steel railings. Eyewitnesses claimed that the aircraft barely cleared the engine test beds next to the Bristol to
South Wales railway embankment. Subsequently, the filling station was moved further north, to a safer location. In the early 1960s a new Filton bypass was constructed, roughly parallel to the old one, and this later became part of the
M5 motorway. The 1960s and 1970s saw the development and production of Concorde at Filton and a further extension of the Filton runway. The first flight of the Concorde 002 prototype took place on 9 April 1969 at Filton Aerodrome. All other British-built Concordes also used the main Filton runway for their first flights. Because of jet blast, gates and traffic lights were installed to close off the
A38 road when Concorde took off. A few
Lightning fighters were produced during this period. The length of the runway and its closed-to-passengers status made it an ideal dispersion site for the nation's airborne nuclear deterrent during the
Cold War. During the
Cuban Missile Crisis in February 1962,
Vulcan Bombers were stationed at the airfield, on short-notice stand-by. opened in 2017 to the north of the old runway. This followed the closure of a previous visitors centre in 2010 after a fatal accident in which a man fell from a walkway. Concorde is one of the exhibits in the
Bristol Aero collection. On 21 November 2006, a public inquiry meeting was held with South Gloucestershire Council to discuss the building of 2,200 homes on the airfield (
Patchway section). The first residents moved in to
Charlton Hayes in October 2010. The aircraft interests of the formerly named British Aircraft Corporation (BAC) are now owned by Airbus, GKN and BAC rebranded as BAE Systems, whilst the aero engine facilities are part of Rolls-Royce.
MBDA owned the guided weapons facilities. Refurbishment by Airbus of Filton House and Pegasus House (both
Grade II listed buildings), as part of a new major office complex, was completed in 2013. Pegasus House, also known as New Filton House, was reopened by the
Duke of Gloucester after standing vacant for 20 years. Built in 1936 as headquarters for the
Bristol Aeroplane Company, the large Art Deco office building has sculptures, plaster panels and foyer flooring by
Denis Dunlop. Next to the A38 road, Airbus UK purchased of the former Rolls-Royce Rodney Works in order to build a facility for wing development and manufacture, which was completed following the granting of planning permission by
South Gloucestershire Council in 2016. ==Units==