X-rays pass through the subject being imaged and strike one of two types of detectors.
Indirect detectors Indirect detectors contain a layer of
scintillator material, typically either
gadolinium oxysulfide or
cesium iodide, which converts the x-rays into light. Directly behind the scintillator layer is an
amorphous silicon detector array manufactured using a process very similar to that used to make
LCD televisions and computer monitors. Like a
TFT-LCD, millions of roughly 0.2 mm
pixels each containing a
thin-film transistor form a grid patterned in amorphous silicon on the glass substrate. Unlike an LCD, but similar to a digital camera's image sensor chip, each pixel also contains a
photodiode which generates an electrical signal in proportion to the light produced by the portion of scintillator layer in front of the pixel. The signals from the photodiodes are amplified and encoded by additional electronics positioned at the edges or behind the
sensor array in order to produce an accurate and sensitive digital representation of the x-ray image.
Direct FPDs Direct conversion imagers utilize
photoconductors, such as amorphous
selenium (a-Se), to capture and convert incident x-ray photons directly into electric charge. X-ray photons incident upon a layer of a-Se generate electron-hole pairs via the internal photoelectric effect. A
bias voltage applied to the depth of the selenium layer draw the electrons and holes to corresponding electrodes; the generated current is thus proportional to the intensity of the irradiation. Signal is then read out using underlying readout electronics, typically by a
thin-film transistor (TFT) array. By eliminating the optical conversion step inherent to indirect conversion detectors, lateral spread of optical photons is eliminated, thus reducing blur in the resulting signal profile in direct conversion detectors. Coupled with the small pixel sizes achievable with TFT technology, a-Se direct conversion detectors can thus provide high spatial resolution. This high spatial resolution, coupled with a-Se's relative high quantum detection efficiency for low energy photons (< 30 keV), motivate the use of this detector configuration for
mammography, in which high resolution is desirable to identify
microcalcifications. ==Advantages and disadvantages==