The metrics of the GII are similar in calculations to the
Inequality-adjusted Human Development Index (IHDI), which was also introduced in the 2010 Human Development Report, and can be interpreted as a percentage loss of human development due to shortcomings in the included dimensions. The value of GII range between 0 and 1, with 0 being 0% inequality, indicating women fare equally in comparison to men and 1 being 100% inequality, indicating women fare poorly in comparison to men. There is a correlation between GII ranks and human development distribution, according to the UNDP countries that exhibit high gender inequality also show inequality in distribution of development, and vice versa. The GII is an association-sensitive, responsive to distributional changes across dimension, composite index used to rank the loss of development through gender inequality within a country. The GII measures inequalities by addressing the shortcomings of other measures through aggregate strategy using
multiple correspondence analysis (MCA) in order to avoid
aggregation problems. There are five steps to computing the gender inequality Index.
Step 1: Treating zeros and extreme values: The maternal mortality rate is truncated systematically at minimum of 10 and maximum of 1,000. The maximum and minimum is based on the
normative assumption that all countries with maternal mortality ratios above 1,000 do not differ in their ability to support for maternal health as well as the assumption that all countries below 10 do not differ in their abilities. Countries with
parliamentary representation reporting at 0 are counted as 0.1 because of the assumption that women have some level of political influence and that the
geometric mean can not have a 0 value.
Step 2: Aggregating across dimensions within each gender group, using geometric means: Aggregating across dimensions for each gender group by the geometric mean makes the GII association-sensitive. The maternal mortality rate and the adolescent fertility rate are only relevant for females the males are only aggregated with the other two dimensions.
Step 3: Aggregating across gender groups, using a harmonic mean: To compute the equally distributed gender index the female and male indices are aggregated by the
harmonic mean of the geometric means to capture the inequality between females and males and adjust for association between dimensions.
Step 4: Calculating the geometric mean of the arithmetic means for each indicator: Obtain the reference standard by aggregating female and male indices with equal weight, and then aggregating indices across dimensions. Reproductive health is not an average of female and male indices but half the distance from the norms established
Step 5: Calculating the Gender Inequality Index: To compute the GII compare the equally distributed gender index from Step 3 to the reference standard from Step 4.
Changes in 2011 calculations According to the UNDP there was a minor calculation change to the 2011 Gender Inequality Index from the 2010 index used. The maternal mortality ratio was calculated in the Gender Inequality Index at 10 even though the range of GII values should be between 0 and 1. To correct this the maternal mortality ratio is normalized by 10, which generally reduced the values of the GII. ==Rankings==