IBM PS/1

The PS/1 line was created for new computer users and was sold in consumer electronics stores alongside comparable offerings from Compaq, Hewlett-Packard, Packard Bell, and others. American PS/1 models came with a modem installed so users could access online IBM help services, which were provided by partnerships with Prodigy and Quantum Computer Services. Like the PCjr, the PS/1's name suggested a more limited machine than IBM's business line, the PS/2. However, unlike the PS/2, the PS/1 was based upon architecture closer to the AT and compatibles, for example using ISA, plain VGA, and IDE. Although the first models used custom-designed components and design, later desktop and tower models used mostly standard components. The earlier models included a ROM with IBM's PC DOS and a graphical shell, however the system was compatible with other DOS implementations and the shell could be installed on the hard drive. Later models included a feature called "Rapid Resume" which gave the computers the ability to go into standby mode as well as a hibernation function. There were several form factors used during the PS/1's production, with the 2133 and 2155 cases used for several model years, while the 2168 tower case was offered later in later models of the PS/1 lineup: • 2011 Proprietary design, power supply is within CRT • 2121 Proprietary design, power supply is within CRT, up to two available ISA slots • 2123 Limited-production model. Based on IBM PS/2 model 30 case, three available ISA slots • 2133 Desktop case. The 3x3 references the available slots and drive bays. • 2155 Desktop case larger than 2133. The 5x5 references the available slots and drive bays, including a 5.25" bay. • 2168 Tower unit. The 6x8 references the available slots and bays, including 5.25" bays. ==Models==

Models 2011 The original PS/1 (Model 2011), based on a 10 MHz Intel 80286 CPU, was designed to be easy to set up and use. It featured 512 KB or 1 MB of on-board memory (expandable to 2.5 MB with proprietary memory modules), built-in modem (in American models only) and an optional 30 MB hard disk. Later models had an optional 40 MB hard disk. IBM also released a 5.25" disk drive unit, a $169 expansion box called Adapter Card Unit (ACU) that could hold three 8/16 bit ISA third-party expansion cards. A $995 CD-ROM drive, based on a Western Digital SCSI chip, could be fitted underneath the case. The first generation of PS/1 models suffered from very limited expansion capabilities, since they lacked standard ISA expansion slots, unless you bought the expansion box (ACU). You could however add up to three $199 512 Kb memory cards, that was easy to install. The original offering was 4 models: • $999 VGA Mono (640x480), 512 Kb RAM • $1.499 VGA Color (640x480), 512 Kb RAM • $1.699 VGA Mono (640x480), 1 Mb RAM, 30 Mb hard disk • $1.999 VGA Color (640x480), 1 Mb RAM, 30 Mb hard disk Model 2121 The 2121 series computers used the same form factor as the 2011 series, but included up to two ISA slots inside the case. Memory could be expanded from 2 MB to 6 MB using a proprietary 4 MB memory module. The higher-end 2121 featured an Intel 80386SX processor running at 16 or 20 MHz. The 2121 series PS/1 computers can be split into the following major hardware categories: Monitors: IBM made the decision to put the DC power supply in the monitor, making use of third-party monitors difficult and essentially impractical and limiting the usefulness of the computer if the monitor needed service (similar to the problems of the Coleco Adam and Amstrad 1512 years earlier). Some models were sold with greyscale VGA monitors. However, some hobbyists could manage to remap the pinouts to allow for third-party monitors. "DOS in ROM”: Similar to a few Tandy 1000 models, the early 2011 and 2121 had an operating system (PC DOS 4.01) built into ROM, rather than loading it from a hard drive. The ROM disk would then load a "4-quad" screen which allowed users to access help, rapidly launch pre-installed software, connect online, and access files on the hard drive. It was possible to have the computer boot from the hard drive if the operating system was upgraded, and IBM provided a DOS 6.22-compatible version of the "4-quad" program that could be launched from the hard drive if users wished to continue using it. Model 2133 The 2133 series PS/1 computers can be split into the following major hardware categories: Model 2168 European models US models Post-"DOS in ROM" models On May 11, 1993, IBM introduced a "new generation" of the PS/1 line. Later PS/1s featured standard LPX-architecture motherboard. Many of these later PS/1s shipped from the factory with MS-DOS and Microsoft Windows, rather than IBM's PC DOS or OS/2. An early 2133 model did come preloaded with OS/2 2.1. This was because IBM targeted OS/2 for high-end computing machines with more power. ==Discontinuation==

The PS/1 line was discontinued in 1994 and replaced with the Aptiva line, which was architecturally very similar to the later models of the PS/1, but with a more marketing-friendly name. Aptivas were sold in the United States until early 2000, when price pressures made the line unprofitable and IBM withdrew from the retail desktop PC market entirely. ==Timeline==