While early generations of CPUs carried out all the steps to execute an instruction sequentially, modern CPUs can do many things in parallel. As it is impossible to just keep doubling the speed of the clock,
instruction pipelining and
superscalar processor design have evolved so CPUs can use a variety of execution units in parallel – looking ahead through the incoming instructions in order to optimise them. This leads to the
instructions per cycle completed being much higher than 1 and is responsible for much of the speed improvements in subsequent CPU generations.
Calculation of IPC The calculation of IPC is done through running a set piece of code, calculating the number of machine-level instructions required to complete it, then using high-performance timers to calculate the number of clock cycles required to complete it on the actual hardware. The final result comes from dividing the number of instructions by the number of CPU clock cycles. The number of
instructions per second and
floating point operations per second for a processor can be derived by multiplying the number of instructions per cycle with the
clock rate (cycles per second given in
Hertz) of the processor in question. The number of instructions per second is an approximate indicator of the likely performance of the processor. The number of instructions executed per clock is not a constant for a given processor; it depends on how the particular
software being run interacts with the processor, and indeed the entire machine, particularly the
memory hierarchy. However, certain processor features tend to lead to designs that have higher-than-average IPC values; the presence of multiple
arithmetic logic units (an ALU is a processor subsystem that can perform elementary arithmetic and logical operations), and short pipelines. When comparing different
instruction sets, a simpler instruction set may lead to a higher IPC figure than an implementation of a more complex instruction set using the same chip technology; however, the more complex instruction set may be able to achieve more useful work with fewer instructions. As such comparing IPC figures between different instruction sets (for example x86 vs ARM) is usually meaningless. == Computer speed ==