Intellec

The first series of Intellecs included the Intellec 4 for the 4004, the Intellec 4 Mod 40 for the 4040, the Intellec 8 for the 8008, and the Intellec 8 Mod 80 for the 8080. The Intellec 4 and 8 were introduced at the June 1973 National Computer Conference in the New York Coliseum. The Intellec computers were not sold to the general public, only to developers, and a very limited number were built. The Intellec 8 retailed for $2,395. == Features ==

The Intellecs have resident monitors stored in ROMs. They also included an assembler, linker, and debugger, as well as the ability to act as an in-circuit emulator. Additionally, a PL/M compiler, cross-assembler and simulator were available, which allowed writing programs in a higher-level language than assembly. FORTRAN compilers were also available. The Intellec 8 supported a Teletype operating at 110 baud, a high speed punched paper tape reader and a CRT terminal at 1200 baud. The Intellec 8 is able to address up to 16 K of memory and came with 5 K pre-installed. The Intellec 4 came with 1 K of PROM and 4 K of RAM for instruction memory, as well as 320 4-bit words of data memory, expandable to 2560 words. The Intellec 8 ran with a two-phase clock of 800 kHz, resulting in an instruction cycle time of 12.5 μs. The Intellec 4 ran at a slower clock rate of 750 kHz, but had a faster instruction cycle time of 10.8 μs. Both systems were available in "Bare Bones" editions, which omitted the front panel, power supply, and completed chassis; instead, it is designed to mount into a rack. Both systems also weighed . ==Usage==

Intel did not market the Intellec as a general-purpose microcomputer, but rather as a development system. As the first microprocessors were intended to run embedded systems such as in calculators, cash registers, scientific instrumentation, computer terminals, printers, plotters, industrial robots, synthesizers, game consoles, and so on, the Intellec was used for programming programmable memory chips used by embedded systems, e.g. the 2048-bit (256-byte) Intel 1602A programmable read-only memory (PROM) or erasable 1702A EPROM chips which were plugged into a ZIF socket on the Intellec-8's front panel. The chip-programming socket is the green device in the lower right corner of the Intellec's front panel. Intel also marketed the Intellec microcomputer development system as a system for developing other OEM microcomputers. ==See also==