Crevasse

, Antarctica Crevasses often have vertical or near-vertical walls, which can then melt and create seracs, arches, and other ice formations. These walls sometimes expose layers that represent the glacier's stratigraphy. Crevasse size often depends upon the amount of liquid water present in the glacier. A crevasse may be as deep as and as wide as where significant summer melting occurs, and the bed of the glacier, where additional water may moisten and lubricate the bed and accelerate ice flow. Direct drains of water from the top of a glacier, known as moulins, can also contribute the lubrication and acceleration of ice flow. ==Types==

, Mount Baker, in the North Cascades, Washington. • Longitudinal crevasses form parallel to flow where the glacier width is expanding. They develop in areas of tensile stress, such as where a valley widens or bends. They are typically concave down and form an angle greater than 45° with the margin. ==Dangers==

(left, 3.768 m) in Tyrolia in Austria in April 2005. There are some zones with large open crevasses, e.g., the spot-shaped area below the middle of the image and most right. The line marks the ascent track of mountaineers on skis which intentionally avoided these dangerous areas. Falling into glacial crevasses can be dangerous and life-threatening. Some glacial crevasses (such as on the Khumbu Icefall at Mount Everest) can be deep, which can cause fatal injuries upon falling. Hypothermia is often a cause of death when falling into a crevasse. A crevasse may be covered, but not necessarily filled, by a snow bridge made of the previous years' accumulation and snow drifts. The result is that crevasses are rendered invisible, and thus potentially lethal to anyone attempting to navigate across a glacier. Occasionally a snow bridge over an old crevasse may begin to sag, providing some landscape relief, but this cannot be relied upon. The danger of falling into a crevasse can be minimized by roping together multiple climbers into a rope team, ==See also==