Several different LMD processes exist, with both the feedstock and laser energy being delivered in different ways and at different locations.
Pre-placed powder The simplest LMD technique involves pre-placed powders. A powder feedstock is placed onto the surface or a substrate, and a focused laser is then scanned or rastered over it, causing the feedstock to melt and fuse with the substrate. Typically an inert shielding gas is used to reduce the oxidation around the melt zone. This process is similar to
selective laser melting, which involves a systematic layer by layer process building an object by selective laser fusion within a bed of powder.
Conventional In conventional powder-fed LMD, a powder
nozzle or nozzles are used, along with a focused laser source. The laser is focused onto the substrate to form a melt pool. Simultaneously, powder is sprayed out of the nozzle as a powder jet plume, directing material into the melt pool, where it melts. As the laser source moves away, the melt pool follows, with the material at the previous location solidifying. This process is typically achieved using a
laser cladding head, which integrates the powder nozzles and the laser optics into one assembly, with both focused at a single target location. The size and area of the melt pool and the powder plume can vary widely, and may take on spot or line configurations, depending on the target application. As for powder-placed LMD, a shielding gas is typically used to minimise oxidation. The carrier gas used to deliver the powder is also typically a shielding gas. The LMD process can be used in many ways, such as by scanning over a wide surface to build up a thin () coating (typically called
laser cladding) or by rastering over one particular area as an
additive manufacturing process to build up objects in 3D layer by layer (sometimes referred to as
directed energy deposition).
High speed High-speed LMD (also known as EHLA) differs from conventional LMD in the focal point of the laser, and in the speed of the cladding process. For high-speed LMD, the focal point is located above the substrate. As powder is sprayed through the focal point, most of the laser energy is absorbed by the powder, where it melts in-flight. This results in molten powder feedstock impacting the substrate, where heat is transferred from the powder into the substrate. This typically results in a lower portion of thermal energy being transferred into the substrate, and as a result high-speed LMD produces a thinner weld bead deposit (typically per pass) with lower dilution and a thinner heat-affected zone compared to conventional LMD. The speed of deposition (the velocity of the melt location on the substrate surface) is typically at least 10 times higher than the speed of conventional LMD, and the rate of material solidification is also faster. The typical effect of these differences, compared to conventional LMD, is a deposit with smoother surface finish, finer grain microstructure, improved corrosion resistance, and higher hardness. Both 2D coatings and 3D additive manufacturing are also possible using high-speed LMD.
Meltio commercializes a wire-laser DED system featuring a coaxial multi-laser deposition head that enables omnidirectional deposition. Its systems use commercially available welding wire (0.8–1.2 mm diameter) as feedstock and are available in blue laser (450 nm) and infrared (976 nm) configurations. This technology has been adopted by the defense forces of the
United States,
France,
Spain, and
South Korea.
Wire feed Similar to
welding processes, LMD can be performed using a metal wire as the feedstock. This can be an advantage the avoids the cost and effort required to produce a
feedstock powder.
Supersonic Supersonic LMD is different from the other LMD processes in that the laser is not used to melt materials. Instead, this is primarily a modified
cold spraying process, which is a type of
solid-state deposition process involving deposition via a
supersonic jet plume of powder. In Supersonic LMD a laser is used to pre-heat the substrate and the powder stream, in order to soften these materials. By avoiding melting, and by operating at a lower temperature, this reduces the chance for oxidation of the feedstock and substrate materials to occur. == See also ==