Mechanical The mechanical component of MEP is an important superset of
HVAC services. Thus, it incorporates the control of environmental factors (
psychrometrics), either for human comfort or for the operation of machines. Heating,
cooling, ventilation and exhaustion are all key areas to consider in the mechanical planning of a building. In special cases, water cooling/heating, humidity control or air filtration may also be incorporated. For example, Google's data centres make extensive use of
heat exchangers to cool their servers. This system creates an additional overhead of 12% of initial energy consumption. This is a vast improvement from traditional active cooling units which have an overhead of 30-70%. and evaporative cooling are efficient alternatives to traditional systems, however they may be more expensive or harder to implement. The job of an MEP engineer is to compare these requirements and choose the most suitable design for the task.
Electricians and
plumbers usually have little to do with each other, other than keeping services out of each other's way. The introduction of mechanical systems requires the integration of the two so that plumbing may be controlled by electrics and electrics may be serviced by plumbing. Thus, the mechanical component of MEP unites the three fields.
Electrical Alternating current Ever since the period between about 1900 and 1920, virtually all modern buildings have integrated some form of AC
mains electricity for powering domestic and everyday appliances. Such systems typically run between 100 and 500 volts, however their classifications and specifications vary greatly by geographical area (see
Mains electricity by country). Mains power is typically distributed through insulated copper wire concealed in the building's subfloor, wall cavities and ceiling cavity. These cables are terminated into sockets mounted to walls, floors or ceilings. Similar techniques are used for lights ("luminaires"), however the two services are usually separated into different circuits with different protection devices at the
distribution board. Whilst the wiring for lighting is exclusively managed by electricians, the selection of luminaires or light fittings may be left to building owners or interior designers in some cases.
Three-phase power is commonly used for industrial machines, particularly motors and high-load devices. Provision for three-phase power must be considered early in the design stage of a building because it has different regulations to domestic power supplies, and may affect aspects such as cable routes, switchboard location, large external transformers and connection from the street. Equivalent names are "low voltage", "data", and "telecommunications" or "comms". A low voltage system used for telecommunications networking is not the same as a
low voltage network. The information technology sector of electrical installations is used for computer networking, telephones, television, security systems, audio distribution, healthcare systems, robotics, and more. These services are typically installed by different tradespeople to the higher-voltage mains wiring and are often contracted out to very specific trades, e.g. security installers or audio integrators. Regulations on low voltage wiring are often less strict or less important to human safety. As a result, it is more common for this wiring to be installed or serviced by competent amateurs, despite constant attempts from the electrical industry to discourage this.
Plumbing Effective
plumbing design helps prevent clashes with other building systems and reduces the risk of costly adjustments or excess materials. In residential settings, plumbing typically includes potable water under mains pressure, hot water systems (often coordinated with mechanical or electrical components), sewerage, stormwater, natural gas, and sometimes rainwater harvesting and storage. In commercial buildings, the range of services is broader, supporting larger user demand and additional functions such as irrigation, hydroponics, fuel supply, oxygen distribution, vacuum or compressed air, and solids handling. Plumbing systems also service air distribution/control, and therefore contribute to the mechanical part of MEP. Plumbing for HVAC systems involves the transfer of coolant, pressurized air, water, and occasionally other substances. Ducting for air transfer may also be consider plumbing, but is generally installed by different tradespeople. == See also ==