ISO standard 1133-1 governs the procedure for measurement of the melt flow rate. The procedure for determining MFI is as follows: • A small amount of the polymer sample (around 4 to 5 grams) is taken in the specially designed MFI apparatus. A
die with an opening of typically around 2 mm diameter is inserted into the apparatus. • The material is packed properly inside the barrel to avoid formation of
air pockets. • A piston is introduced which acts as the medium that causes extrusion of the molten polymer. • The sample is preheated for a specified amount of time: 5 min at 190 °C for polyethylene and 6 min at 230 °C for polypropylene. • After the preheating a specified weight is introduced onto the piston. Examples of standard weights are 2.16 kg, 5 kg, etc. • The weight exerts a force on the molten polymer and it immediately starts flowing through the die. • A sample of the melt is taken after the desired period of time and is weighed accurately. • MFI is expressed in grams of polymer per 10 minutes of duration of the test. Synonyms of Melt Flow Index are
Melt Flow Rate and
Melt Index. More commonly used are their abbreviations:
MFI,
MFR and
MI. Confusingly, MFR may also indicate "melt flow ratio", the ratio between two melt flow rates at different gravimetric weights. More accurately, this should be reported as FRR (flow rate ratio), or simply flow ratio. FRR is commonly used as an indication of the way in which rheological behavior is influenced by the molecular weight distribution of the material. formerly: (
MFI =
Melt Flow Index) → currently: (
MFR =
Melt mass-Flow Rate) formerly: (
MVI =
Melt Volume Index) → currently: (
MVR =
Melt Volume-flow Rate) formerly: (
MFR =
Melt Flow Ratio) → currently: (
FRR =
Flow Rate Ratio) The flow parameter that is readily accessible to most processors is the MFI. MFI is often used to determine how a polymer will process. However, MFI takes no account of the shear,
shear rate or shear history and as such is not a good measure of the processing window of a polymer. It is a single-point viscosity measurement at a relatively low shear rate and temperature. Earlier, it was often said that MFI give a ‘dot’ when actually what is needed is a ‘plot’ for the polymer processors. However, this is not true now because of a unique approach developed for estimating the rheogram merely from the knowledge of the MFI. The MFI device is not an extruder in the conventional polymer processing sense in that there is no screw to compress, heat and shear the polymer. MFI additionally does not take account of long chain branching nor the differences between shear and elongational
rheology. Therefore, two polymers with the same MFI will not behave the same under any given processing conditions. The relationship between MFI and temperature can be used to obtain the activation energies for polymers. The activation energies developed from MFI values has the advantage of simplicity and easy availability. The concept of obtaining
activation energy from MFI can be extended to copolymers as well wherein there exists an anomalous temperature dependence of melt viscosity leading to the existence of two distinct values of activation energies for each copolymer. For a detailed numerical simulation of the melt flow index, see or. ==Melt Flow Index Formula==