The problem of coronal heating is still unsolved, although research is ongoing and other evidence of nanoflares has been found in the solar corona. The amount of energy stored in the
solar magnetic field can account for the coronal heating necessary to maintain the plasma at this temperature and to balance
coronal radiative losses. The radiation is not the only mechanism of energy loss in the corona: since the
plasma is highly ionized and the magnetic field is well organized, the thermal conduction is a competitive process. The energy losses due to the thermal conduction are of the same order of coronal radiative losses. The energy released in the corona which is not radiated externally is conducted back towards the
chromosphere along the arcs. In the
transition region where the temperature is about 104 -105 K, radiative losses are too high to be balanced by any form of mechanical heating. The very high temperature gradient observed in this range of temperatures increases the conductive flux in order to supply for the irradiated power. In other words, the transition region is so steep (the temperature increases from 10 kK to 1 MK in a distance of the order of 100 km) because the thermal conduction from the superior hotter atmosphere must balance the high radiative losses, as indicated to the numerous
emission lines, which are formed from ionized atoms (oxygen, carbon, iron and so on). The solar convection can supply the required heating, but in a way not yet known in detail. Actually, it is still unclear how this energy is transmitted from the chromosphere(where it could be absorbed or reflected), and then dissipated into the corona instead of dispersing into the solar wind. Furthermore, where does it occur exactly? In the low
corona or mainly in the higher corona, where the magnetic field lines open into the space
heliosphere, driving the
solar wind into the
Solar System. The importance of the magnetic field is recognized by all the scientists: there is a strict correspondence between the
active regions, where the irradiated flux is higher (especially in the X-rays), and the regions of intense magnetic field. The problem of coronal heating is complicated by the fact that different coronal features require very different amounts of energy. It is difficult to believe that very dynamic and energetic phenomena such as flares and coronal mass ejections share the same source of energy with stable structures covering very large areas on the Sun: if nanoflares would have heated the whole corona, then they should be distributed so uniformly so as to look like a steady heating. Flares themselves – and microflares, which when studied in detail seem to have the same physics – are highly intermittent in space and time, and would not therefore be relevant to any requirement for continuous heating. On the other hand, in order to explain very rapid and energetic phenomena such as solar flares, the magnetic field should be structured on distances of the order of the metre. ) The
Alfvén waves generated by convective motions in the
photosphere can go through the
chromosphere and
transition region, carrying an energy flux comparable to that required to sustain the
corona. Anyway, wavetrain periods observed in the high chromosphere and in the lower transition region are of the order of 3-5 min. These times are longer than the time taken by Alfvén waves to cross a typical coronal loop. This means that most of the dissipative mechanisms may provide enough energy only at distances further from the solar corona. More probably, the Alfvén waves are responsible for the acceleration of the
solar wind in
coronal holes. The theory initially developed by Parker of micro-nanoflares is one of those explaining the heating of the corona as the dissipation of electric currents generated by a spontaneous relaxation of the magnetic field towards a configuration of lower energy. The magnetic energy is thus transformed into
Joule heating. The braiding of the field lines of the coronal magnetic flux tubes provokes events of
magnetic reconnection with a consequent change of the
magnetic field at small length-scales without a simultaneous alteration of the magnetic field lines at large length-scales. In this way it can be explained why
coronal loops are stable and so hot at the same time. The Ohmic dissipation by currents could be a valid alternative to explain the coronal activity. For many years the
magnetic reconnection has been invoked as the main power source of
solar flares. However this heating mechanism is not very efficient in large
current sheets, while more energy is released in turbulent regimes when nanoflares happen at much smaller scale-lengths, where non-linear effects are not negligible. The complete lifecycle of a nanoflare has been reported. The researchers documented the process of selective ion heating via
magnetic reconnection within low-lying, previously unresolved solar
coronal loops. These loops were observed to undergo rapid heating from temperatures of a few thousand degrees Celsius to several million degrees within a span of tens of seconds, followed by a gradual cooldown, delivering enough energy to heat the corona to multi-million degree Celsius. == See also ==