Pin weaving

The equipment needed is minimal, consisting of pins, a pinnable board, and a bodkin needle. It can also be done on some types of knitting frame. There are also commercial looms made for pin weaving. Smooth, rounded pin tops are desirable; they don't snag the yarn or fingers. The pins may be numbered (with numbers written beside the pins), and the lower-left corner may be marked, for ease of reference when working patterns. Ideally, the background should contrast with the threads. File:WEAVING WITH A PIN (cropped).jpg|Weaving by wrapping the warp and weft threads between pins stuck into a pinnable surface (in this case, cork; foamcore is also used.). File:Zoom loom square.jpg|Pin weaving on a mass-produced pin loom ==Weaves==

For plain tabby weaves, only every other thread in one direction (a quarter of the yarns) is inserted over-and-under with a needle. The others are wrapped in layers; first the odd warps, then the odd counterwarps (at 90 degrees to the warp threads), then the even warp threads. The counterwarps thus pass alternately over and under the warps, but they do it in parallel, passing over and under in unison. A weft thread is woven between each pair of counterwarps, passing under where the flanking counterwarps pass over, and vice-versa. This timesaving method cannot be used for more complex weaves, such as twills. For these, the odd warps are warped, then the even warps are warped (giving the edge loops), and then the weft is woven with the needle. There is no counterwarp. File:Weave-It Book Number 1 (1936), pin-weaving pattens (page 25 crop to counterwarp weaving method).jpg|1. Odd warps are warped2. Odd counterwarps are warped, at right angles to the warps3. Even warps are warped4. Weft is woven, filling in the spaces between the counterwarps File:Weave-It Book Number 1 (1936), pin-weaving pattens (page 29 crop to tabby weave diagram).jpg|Partway through stage four of a tabby weave, on a commercial loom. Weave-It Book Number 1 (1936), pin-weaving pattens (page 26 crop to twill weave diagram).jpg|Weaving a twill; no counter-warp. Jiffy-Loom Book of Novelty Weaving, Original Ideas and Patterns (1942), pin-weaving (page 16, showing patterned twill weave).jpg|Weaving a patterned twill. Note that an even pin spacing gives an uneven yarn spacing; pins clustered in threes produce an even yarn spacing. File:PIN WEAVING IN COTTON AND SILK.jpg|Cotton-and-silk weft-faced tapestry on pins in cork sheet; the complexity of the weft means it has to be woven manually ==Joining and edging==

Pin-woven textiles are small, and are often stitched together into larger textiles; the finished product has visible seams. Joining methods including whip stitch, cross stitch, running stitch, back stitch; overcast stitch is fast but tends to pucker. In crochet, crocheted slip stitch and single crochet are used, as are knitted 3-needle bind-offs. Weave-It Weaves Book Number 1 (1943), pin-weaving pattens (page 9 crop to joining methods).jpg|Two joining methods, termed "lacy stitch" and "cross stitch" Original Loomette Weaves (1937), pin weaving (page 16, joining methods).jpg|Decorative joining methods: overcast stitch, featherstitches, and an overcast stitch with an extra turn File:Weave-It Book Number 2 (1936), pin-weaving pattens (page 29 crop to overcast-stitch joining diagram).jpg|An overcast-stitch join tends to pucker Original Loomette Weaves, Revised edition with improved joining method described, 1949 (page 9, joining instructions).jpg|A manual lockstich to create a smoother seam File:Collection of zoom loom squares.jpg|Squares with crochet borders Weave-It Book Number 7 (1939), pin-weaving pattens (page 22, slip-on sweater pattern).jpg|Sweater pattern with waist and cuffs of ribbed knitting, and crochet-edged collar. ==Patterns==

File:Novelty Weaving Suggestions, Jiffy-Loom Patterns, Original Ideas (1937) (page 1 crop).jpg|Woven patterns on the cover of a 1937 pattern-book File:The Loomette Handbook; New weaves, vogues, and suggestions; 1938 (page 13 crop; "Warmee" coat).jpg|Coat from a 1938 patternbook. Seams between squares can be seen. Note rectangular garment construction, with underarm gussets made from squares folded on the diagonal, and tarikubi collar. File:The Loomette Handbook; New weaves, vogues, and suggestions; 1938 (page 14 crop to "Little Princess Baby Set" baby blanket).jpg|Textured-weave baby blanket from the same pattern book. Seams between squares are used decoratively. Weave-It Book Number 2 (1936), pin-weaving pattens (page 14 crop to shoulder-buttoned sweater).jpg|A shoulder-buttoned sweater, made with full-sized and quartered-sized squares (1936 pattern). Knit waist and cuffs. Weave-It Book Number 2 (1936), pin-weaving pattens (page 17 crop to shoulder-buttoned sweater pattern).jpg|Pattern for the sweater in the previous image, showing rectangular construction. File:The Loomette Handbook; New weaves, vogues, and suggestions; 1938 (page 3 crop to sub-squares).jpg|Some commercial looms have bars used to make fractional-sized squares. Weave-It Book Number 3 (1937), pin-weaving pattens (page 4 crop to evening cape with eased horizontal seams).jpg|Eased horizontal seams in a pattern for an evening cape, 1937. The Loomette Handbook; New weaves, vogues, and suggestions; 1938 (page 3 crop to layout and cutting).jpg|Cutting curved pattern-pieces Many sewing patterns designed for pinweaving use rectangular construction, with all seams lying on selvage edges. This eliminates waste. Others use non-rectangular construction, cutting curve-edged pattern pieces out of a piece of cloth formed by sewing together the squares. Garments can be cut on the bias or on the grain with similar amounts of waste. Seams joing the squares may be eased; that is, there are more squares on one side of the join than on the other. The extra length is distributed evenly along the seam, creating fullness without discrete pleats. ==Similar methods==

Darning looms are similar to pin weaving, but instead of being wrapped around pins, three of the selvages are stitched into the cloth being repaired. The fourth is wrapped around a revolving-hood mechanism which, when rotated, forms a shed and countershed, making plain tabby weaves much faster. When finished, the hooks are removed, and the fourth selvage is usually stitched to the cloth. ==Publications==

Early twentieth-century • Original Loomette Weaves, Revised edition with improved joining method described, by Loomette Studios. Public-domain fulltext. • The Loomette Handbook; New weaves, vogues, and suggestions, by Loomette Studios. Public-domain fulltext. • See :Commons:Category:Pin-weaving publications for more public-domain books • See also eLoomaNation for more free fulltexts 21st-century • Stump, Margaret (2002). Weavies One. PO Box 255, Buffalo Lake, Minnesota, 55314, self-published. • Spencer, Hazel (2003). Weaving On Hazel Rose Looms. Rt. 2, Box 4792, Trinity Center, California, 96091, self-published. • Spencer, Hazel (2003). Quilt Weaver Looms.Rt. 2, Box 4792, Trinity Center, California, 96091, self-published. • • • • • • ==References==