Preparations of the veneers The creation of pressed wood begins with the
veneers being placed in a
rotary dryer. This dryer is typically heated with steam at around . This process prepares the veneers for the humidifying process in which the veneers are then placed into humidification chambers. These humidification chambers have a precise
moisture content.
Applying adhesive to the veneers After the veneers have been prepared,
resin adhesive is applied to the top of the veneer and then rolled for equal distribution on top of the veneer. Next, another veneer with a perpendicular grain pattern is applied on top. This process is then repeated until the desired thickness of the board is met.
Pressing Once the board is at its desired thickness, the board is placed into a
press, where the board is pressed and heated. This process gives pressed
wood its strength advantage over other
engineered wood types. The boards are placed in a press where the press will press down on the boards with roughly of pressure. At the same time, the boards will also be heated up to —this heat and pressure cause the adhesive to cure, forming the finished board. == Applications of pressed wood ==