,
Texas (1901) Blowout preventers come in a variety of designs, sizes and pressure ratings. Several individual units serving various functions are combined to compose a blowout preventer stack. Multiple blowout preventers of the same type are frequently provided for
redundancy, an important factor in the effectiveness of
fail-safe devices. The primary functions of a blowout preventer system are to: • Confine well fluid to the
wellbore; • Provide means to add fluid to the wellbore; • Allow controlled volumes of fluid to be withdrawn from the wellbore. Additionally, and in performing those primary functions, blowout preventer systems are used to: • Regulate and monitor wellbore pressure; • Center and hang off the
drill string in the wellbore; • Shut in the well (e.g. seal the void,
annulus, between drill pipe and casing); •
Kill the well (prevent the flow of
formation fluid, influx, from the reservoir into the wellbore); • Seal the
wellhead (close off the wellbore); • Sever the
casing or
drill pipe (in case of emergencies). In drilling a typical high-pressure well, drill strings are routed through a blowout preventer stack toward the
reservoir of oil and gas. As the well is drilled,
drilling fluid, called
mud, is fed through the drill string down to the drill bit, the
blade, and returns up the wellbore in the ring-shaped void, the annulus, between the outside of the drill pipe and the casing (piping that lines the wellbore). The column of drilling mud exerts downward
hydrostatic pressure to counter opposing pressure from the formation being drilled, allowing drilling to proceed. When a
kick (influx of formation fluid) occurs, rig operators or automatic systems close the blowout preventer units, sealing the annulus to stop the flow of fluids out of the wellbore. Denser mud is then circulated into the wellbore down the drill string, up the annulus and out through the choke line at the base of the BOP stack through chokes (flow restrictors) until downhole pressure is overcome. Once
kill weight mud extends from the bottom of the well to the top, the well has been
killed. If the integrity of the well is intact drilling may be resumed. Alternatively, if circulation is not feasible it may be possible to kill the well by
bullheading, forcibly pumping in the heavier mud from the top through the kill line connection at the base of the stack. This is less desirable because of the higher surface pressures likely needed and the fact that much of the mud originally in the annulus must be forced into receptive formations in the open hole section beneath the deepest casing shoe. If the blowout preventers and mud do not restrict the upward pressures of a kick, a blowout may result, potentially shooting tubing, oil and gas up the wellbore, damaging the rig, and leaving
well integrity in question. Since BOPs are important for the safety of the crew and natural environment, as well as the
drilling rig and the wellbore itself, authorities recommend, and regulations require, that BOPs be regularly inspected, tested and refurbished. Tests vary from daily test of functions on critical wells to monthly or less frequent testing on wells with low likelihood of control problems. Exploitable reservoirs of oil and gas are increasingly rare and remote, leading to increased subsea deepwater well exploration and requiring BOPs to remain submerged for as long as a year in extreme conditions. As a result, BOP assemblies have grown larger and heavier (e.g. a single ram-type BOP unit can weigh in excess of 30,000 pounds), while the space allotted for BOP stacks on existing offshore rigs has not grown commensurately. Thus a key focus in the technological development of BOPs over the last two decades has been limiting their footprint and weight while simultaneously increasing safe operating capacity. ==Types==