Semi-solid metal casting

Thixomolding was invented by Dow Chemical in the 1980s by converting a plastic extruder. They transferred their 1987 patent in 1990 to Thixomat Inc. Japan Steel Works Ltd. and Husky Injection Molding Systems Ltd. licensed the technology. However, in 2024 Idra launched its thixomolding machines that adopted thixotropic piston injection (TPI). ==Processes==

Four techniques involve semi-solid castings. For aluminum alloys the more common processes are thixocasting, rheocasting, and SIMA. With magnesium alloys, the most common process is thixomolding. Thixocasting Thixocasting utilizes a pre-cast billet with a non-dendritic microstructure that is normally produced by vigorously stirring the melt as the bar is being cast. Induction heating is normally used to re-heat the billets to the semi-solid temperature range, and die casting machines are used to inject the semi-solid material into hardened steel dies. Thixocasting is employed commercially. Thixocasting can produce high quality components due to the product consistency that results from using pre-cast billets manufactured under the same ideal continuous processing conditions that are employed to make forging or rolling stock. The main disadvantage is that it is expensive due to the specialized billets, although facilities with in house magnetohydrodynamic continuous casting capabilities can recycle 100% of in-house returns. Other disadvantages include support for a limited number of alloys, and in-house magnetohydrodynamic casting capability to directly reuse scrap. Rheocasting Rheocasting develops the semi-solid slurry from the molten metal produced in a typical die casting furnace. The flow of the material is less turbulent, creating near-zero porosity. The slower velocity of the material into the die extends die life by more than 2x. Slurry module Thixotropic piston injection adds the slurry-forming screw as a module for traditional die casting machines. It retains the use of the existing injection piston to provide sufficient pressure, while using the screw to prepare (semi-melt) the metal. It further eliminates holding and melting furnaces (that otherwise melt the metal), preventing alloy separation during holding. Strain-induced melt-activated (SIMA) In the SIMA method the material is first heated to the SMM temperature. As it nears the solidus temperature the grains recrystallize to form a fine grain structure. After the solidus temperature is passed the grain boundaries melt to form the SSM microstructure. For this method to work the material should be extruded or cold rolled in the half-hard tempered state. This method supports bar diameters only smaller than . ==Advantages==

High consolidation pressures are used to produce high integrity parts. The advantages of semi-solid casting are: • Complex parts produced net shape • Pore free • Reduced shrinkage • Mechanical performance • Pressure tightness • Tight tolerances • Thin walls • Heat treatable (T4/T5/T6) • Good surface finish • Lower casting temperature • Uses conventional tool steel materials • Ease of automation • Production rates equal to or better than die casting rates • Uniform microstructure. • Relatively insensitive to ambient temperature since small heat losses cause only minor changes in fraction solid. ==Disadvantages==

Production facilities require a higher degree of control over process conditions, • Requires higher final injection pressures • Requires lower injection velocities. • Requires on-site magneto-hydrodynamic continuous casting capabilities in order to completely recycle in-house material returns. • Lack of suitable high temperature die materials limits the casting of high melting point metals, such as tool steel and stellite, to experimental applications. ==See also==