The ultrasonic immersion method makes use of a temperature stabilised
water bath which has a pair of ultrasonic
transducers located on either side of the sample which can be rotated using a
stepper motor. The time of flight of an ultrasonic
pulse that has been transmitted through the material is measured using an electronic timer that determines the start of the transmitted pulse and the start of the received pulse using threshold detection. This timer is typically accurate to
microsecond or better resolution. By rotating the sample, time of flight measurements can be obtained a range of angles of incidence, typically up to 40 degrees. From the time of flight, the phase velocity can be determined as a function of the angle of incidence of the ultrasonic pulse. Using
Christoffel's equations, the measured data can be fitted using a least squares numeric method to determine six of the nine elastic constants. By slicing the composite material and re-arranging the slices, the method can be re-applied to obtain the remaining three constants not found from the original measurements. ==References==