Edward Teller's goal was an "inherently safe" reactor, meaning that even if all the
control rods are abruptly withdrawn, the reactor will settle to a stable state before it is damaged by the heat. To achieve this it needs to have a large negative
temperature coefficient, i.e. the amount of reactivity should decrease quickly as the reactor gets hotter. Most nuclear reactors exhibit a negative temperature coefficient to some extent. As fuel temperature rises, thermal expansion reduces the fuel density, lowering reactivity. In addition, the neutron absorption of
U-238 (the non-fissile uranium isotope) increases with temperature due to
Doppler broadening, increasing neutron capture and thereby reducing the number of neutrons available to sustain the fission chain reaction. The TRIGA design additionally makes use of effects related to the energy of thermal neutrons. Like most reactors, TRIGA is a
thermal-neutron reactor in which fast neutrons produced by fission are slowed by a
neutron moderator until they reach thermal equilibrium with the surrounding material. The
U-235 fission cross section is much larger for low-energy neutrons than for higher-energy ones. As the temperature of the moderator increases, the average energy of thermal neutrons also increases, reducing the probability that they will induce fission and increasing the likelihood that they will escape from the fuel (the "leakage effect") and be absorbed elsewhere. An even larger negative coefficient can be obtained by incorporating neutron absorbers such as
erbium into the fuel, which preferentially absorb higher-energy thermal neutrons. The challenge of exploiting the leakage effect was to ensure that the temperature of the neutrons tracks the temperature of the reactor. In general the thermal energy of the neutrons will always correspond closely to the temperature of the moderator. But in a conventional reactor the moderator is separate from the fuel; for example a
light-water reactor uses water next to the fuel rods as a neutron moderator. If there is a power surge in such a reactor, the fuel rods can heat up and melt long before the water starts to heat up. Therefore, the TRIGA designers set out to make a "homogeneous reactor", where the fissionable material and the moderator are combined in a homogeneous mixture. The TRIGA fuel consists of a homogeneous alloy of uranium-zirconium hydride. The zirconium matrix can hold a large number of hydrogen atoms (with a H/Zr ratio around 1.6), and the hydrogen is a good moderator. Water surrounding the fuel provides additional moderation and cooling. Because the uranium is dispersed inside the zirconium hydride matrix, the temperature of the hydrogen and hence the thermal neutrons instantly track the rest of the fuel. Using standard TRIGA fuel, 50% of the temperature coefficient of the reactor is due to the thermal spectrum of the neutrons. == List of all TRIGA Nuclear reactors built around the world==