As Televisión Española adopted the PAL colour system in 1975, From the early 1990s onwards the appearance of the test card changed, with the station name becoming a graphic and clock font now being identical to that of the
PM5644 (which was available by that time and likely to explain such changes) thus the original hardware was likely replaced.
Castellations The alternating white and black boxes around the perimeter are called castellations. They are used to set
overscan (castellations should be visible) and check for the low-frequency response of the entire transmission chain.
Grid The background features a grid composed of perfect squares of 100% intensity white lines. This element allows for: • Verifying the geometry of the image (horizontal and vertical size and linearity,
cushion or
barrel distortion effects); • Adjusting the
CRT convergence (the three
electron guns, one for each
primary color, need to target the same place); • Adjusting the CRT focus; • Checking the CRT color purity when displaying the 50% intensity gray background.
Rectangle This element is composed of an orange rectangle, framed with a white line, and located at the image center. It allows for: • Checking proper
chrominance delay, essential for good PAL system operation; • Visualizing low-frequency image distortions; • Adjusting maximum color saturation. Signal values of this element are:
Circle This element is composed of a light blue circle, also located at the center of the image. With a diameter of 512 lines, it overlaps the rectangle mentioned previously. The circle provides a quick overview of image geometry. Signal values of this element are:
Box Located at the top of the circle and composed of 100% white lines, it allows for verification of the low-frequency response of the transmission chain.
Colour bars Inside the circle, there's a section of
colour bars with 75% amplitude and 100% saturation (
EBU color bars), that allows checking chrominance parameters on a
vectorscope or
waveform monitor. The signal values of these bars are:
Centre Grid This element is composed of 100% white lines located at the centre of the image, between the colour bars and the greyscale. It helps with image centring adjustment and allows checking for
CRT convergence at the centre of the screen.
Greyscale Bars Beneath the colour bars, there's a greyscale bar with six steps. This allows checking
gamma correction of the television receiver, and linearity response of the transmission chain. The brightness value of each step varies with a ratio of 20%, as follows:
Grating Bars Located within the circle, the gratings are composed of alternating white and black lines. Horizontal frequency response (
horizontal resolution) can be determined by five frequency gratings of 0.5, 1.25, 2.25, 4.2, and 4.8
MHz. The last two gratings must show interference from the 4.43 MHz PAL
colour carrier.
Pulse Signal A pulse signal bar is placed under the frequency gratings, consisting of a black rectangle with a white vertical line, corresponding to a 2T pulse. This signal shows the status of the transmission chain at high frequencies, as well as
ghosting due to signal echoes.
Station Identification Other elements like TV network identification ("TVE", "La Primera", "TVE2", "Teledeporte", "Canal Clásico", "TVE Internacional"), specific TV channel logos or a clock were usually added to the test pattern. == See also ==