Flight deck

Early The first flight decks were inclined wooden ramps built over the forecastle of warships. Eugene Ely made the first fixed-wing aircraft take-off from a warship from on 14 November 1910. Two months later, on 18 January 1911, Ely landed his Curtiss pusher plane on a platform on anchored in San Francisco Bay using the first tailhook system, designed and built by circus performer and aviator Hugh Robinson. Ely told a reporter: "It was easy enough. I think the trick could be successfully turned nine times out of ten." On 9 May 1912, Commander Charles Samson became the first man to take off from a ship which was underway when he flew his Short S.27 off , which was steaming at . Because the take-off speed of early aircraft was so low, it was possible for an aircraft to make a very short take off when the launching ship was steaming into the wind. Later, removable "flying-off platforms" appeared on the gun turrets of battleships and battlecruisers starting with , allowing aircraft to be flown off for scouting purposes, although there was no chance of recovery. On 2 August 1917, while performing trials, Squadron Commander Edwin Harris Dunning landed a Sopwith Pup successfully on board the flying-off platform of , becoming the first person to land an aircraft on a moving ship. However, on his third attempt, a tire burst as he attempted to land, causing the aircraft to go over the side, killing him; thus Dunning also has the dubious distinction of being the first person to die in an aircraft carrier landing accident. The landing arrangements on Furious were highly unsatisfactory. In order to land, aircraft had to maneuver around the superstructure. Furious was therefore returned to dockyard hands to have a deck added aft for landing, on top of a new hangar. The central superstructure remained, however, and turbulence caused by it badly affected the landing deck. Full length The first aircraft carrier that began to show the configuration of the modern vessel was the converted liner , which had a large flat wooden deck added over the entire length of the hull, giving a combined landing and take-off deck unobstructed by superstructure turbulence. Because of her unobstructed flight deck, Argus had no fixed conning tower and no funnel. Rather, exhaust gases were trunked down the side of the ship and ejected under the fantail of the flight deck (which, despite arrangements to disperse the gases, gave an unwelcome "lift" to aircraft immediately prior to landing). The lack of a command position and funnel was unsatisfactory, and Argus was used to experiment with various ideas to remedy the solution. A photograph in 1917 shows her with a canvas mock-up of a starboard "island" superstructure and funnel. This was placed on the starboard side because the rotary engines of some early aircraft created torque which pulled the nose left, meaning an aircraft naturally yawed to port on take-off; therefore, it was desirable that they turned away from the fixed superstructure. This became the typical aircraft carrier arrangement and was used in the next British carriers, and . After World War I, battlecruisers that otherwise would have been discarded under the Washington Naval Treaty—such as the British and , the American and , and the Japanese and battleship —were converted to carriers along the above lines. Being large and fast they were perfectly suited to this role. The heavy armoring and scantlings and low speed of the converted battleship Eagle served to be something of a handicap in practice. Because the military effectiveness of aircraft carriers was then unknown, early ships were typically equipped with cruiser-calibre guns to aid in their defense if surprised by enemy warships. These guns were generally removed in World War II and replaced with anti-aircraft guns, as carrier doctrine developed the "task force" (later called "battle group") model, where the carrier's defense against surface ships would be a combination of escorting warships and its own aircraft. In ships of this configuration, the hangar deck was the strength deck and an integral part of the hull, and the hangar and light steel flight deck were considered to be part of the superstructure. Such ships were still being built into the late 1940s, classic examples being the U.S. Navy's and carriers. However, in 1936, the Royal Navy began construction of the . In these ships, the flight deck was the strength deck, an integral part of the hull, and was heavily armored to protect the ship and her air complement. The flight deck as the strength deck was adopted for later construction. This was necessitated by the ever-increasing size of the ships, from the 13,000 ton in 1922 to over 100,000 tons in the latest and carriers. Armored When aircraft carriers supplanted battleships as the primary fleet capital ship, there were two schools of thought on the question of armor protection being included into the flight deck. The United States Navy (USN) initially favored unarmored flight decks because they maximized aircraft carrier hangar and flight deck size, which in turn maximized aircraft capacity in the hangar, and on the flight deck, in the form of a permanent "deck park" for a large proportion of the aircraft carried. In 1936 the Royal Navy developed the armored flight deck aircraft carrier which also enclosed the hangar sides and ends with armor. The addition of armor to the flight deck offered aircraft below some protection against aerial bombs while the armored hangar sides and ends helped to minimize damage and casualties from explosions or fires within or outside the hangar. The addition of armor to the hangar forced a reduction in top-weight, so the hangar height was reduced, and this restricted the types of aircraft that these ships could carry, although the Royal Navy's armored carriers did carry spare aircraft in the hangar overheads. The armor also reduced the length of the flight deck, reducing the maximum aircraft capacity of the armored flight deck aircraft carrier. Additionally, Royal Navy aircraft carriers did not use a permanent deck park until approximately 1943; before then the aircraft capacity of RN aircraft carriers was limited to their hangar capacity. The 23,000-ton British had a hangar capacity for 36 Swordfish-sized aircraft and a single hangar, but carried up to 57 aircraft with a permanent deck park, while the 23,400-ton featured increased hangar capacity with a upper hangar and the addition of a lower hangar, forward of the after elevator, which had a total capacity of 52 Swordfish-sized aircraft or a mix of 48 late-war aircraft in the hangar plus 24 aircraft in a permanent deck park, but carried up to 81 aircraft with a deck park. The 27,500-ton USN had a hangar that was designed to handle a mix of 72 prewar USN aircraft. but carried up to 104 late-war aircraft using both the hangar and a permanent deck park. The experience of World War II caused the USN to change their design policy in favor of armored flight decks on much larger ships: "The main armor carried on is the heavy armored flight deck. This was to prove a significant factor in the catastrophic fire and explosions that occurred on Enterprises flight deck in 1969. The US Navy learned its lesson the hard way during World War II when all its carriers had only armored hangar decks. All attack carriers built since the have had armored flight decks." ==Landing==

Landing arrangements were originally primitive, with aircraft simply being "caught" by a team of deck-hands who would run out from the wings of the flight deck and grab a part of the aircraft to slow it down. This dangerous procedure was only possible with early aircraft of low weight and landing speed. Arrangements of nets served to catch the aircraft should the latter fail, although this was likely to cause structural damage. A non-skid deck surface is important to prevent aircraft from sliding on a wet deck as the ship rolls. Landing larger and faster aircraft on a flight deck was made possible through the use of arresting cables installed on the flight deck and a tailhook installed on the aircraft. Early carriers had a very large number of arrestor cables or "wires". Current U.S. Navy carriers have three or four steel cables stretched across the deck at intervals which bring a plane, traveling at , to a complete stop in about . The cables are set to stop each aircraft at the same place on the deck, regardless of the size or weight of the plane. During World War II, large net barriers would be erected across the flight deck so aircraft could be parked on the forward part of the deck and recovered on the after part. This allowed increased complements but resulted in a lengthened launch and recovery cycle as aircraft were shuffled around the carrier to allow take-off or landing operations. A barricade is an emergency system used if a normal arrestment cannot be made. Barricade webbing engages the wings of the landing aircraft, and momentum is transferred to the arresting engine. ==Cold War innovations==

Angled flight deck on angled flight deck, , showing how the offset recovery area allows for simultaneous launch and recovery operations. The angled flight deck was invented by Royal Navy Captain (later Rear Admiral) Dennis Cambell, as an outgrowth of design study initially begun in the winter of 1944–1945. A committee of senior Royal Navy officers decided that the future of naval aviation was in jets, whose higher speeds required that the carriers be modified to suit their needs. In this type of deck—also called a "skewed deck", a "canted deck", a "waist angle deck", and the "angle"—the aft part is widened, and a separate runway, dedicated to landing, lies at an angle oblique to the centreline. The angled flight deck was designed with the higher landing speeds of jet aircraft in mind, which would have required the entire length of a centreline flight deck to stop. Despite the new markings, in both cases the arresting gear and barriers were still aligned with the centerline of the original deck. From September to December 1952, had a rudimentary sponson installed for true angled-deck tests, allowing for full arrested landings, which proved during trials to be superior. was modified with an overhanging angled flight deck in 1954. With the introduction of jet aircraft the risk of damaging propellers was no longer an issue, though take off would require some sort of launching cradle. Tests were carried out with a de Havilland Sea Vampire flown by test pilot Eric "Winkle" Brown onto a flexible deck fitted to . The deck consisted of a rubberised sheet fully supported on multiple layers of pressurised fire hose. Supermarine designed its Type 508 for rubber deck landings. The flexible deck idea was found to be technically feasible but was abandoned, as the weight of carrier aircraft increased and there were always doubts about the ability of an average pilot to land in this way. The Type 508 was subsequently developed into a conventional carrier aircraft, the Supermarine Scimitar. The US Navy evaluated a shore-based flexible deck made by Firestone Tire and Rubber Co. using two modified Grumman F9F-7 Cougars. Three US pilots had participated in the British flexible deck trials at Farnborough and the US Navy, despite liaison with the British, partially redid the Farnborough trials, with 23 landings at Patuxent River, before cancelling the project in March 1956 for similar reasons. ==Alternatives==

During the Cold War era, multiple unorthodox alternatives to the conventional flight deck were proposed and, in some cases, experimented with. The Shipborne Containerised Air-defence System (SCADS) was a proposed modular kit to convert a RO-RO or container ship into aviation vessels, with one scheme allowing a container ship to be converted to a STOVL aircraft carrier in two days during an emergency and quick removal after use for storage. A prefabricated flight deck and ski jump would allow six Sea Harriers and two helicopters to be operated, with shipping containers providing hangarage for the aircraft and housing their support systems and personnel as well as defensive systems and missiles. Several variants of the SCADS concept were devised for different missions roles; one implementation was tailored towards helicopter operations for example. It was effectively a modern equivalent to the Second World War-era merchant aircraft carrier. The Skyhook system was developed by British Aerospace, involving the use of a crane with a top mating mechanism hung over the sea to catch and release VTOL aircraft, such as the Harrier jump jet. The system could be installed on ships of various configurations and sizes, even those as small as frigates, enabling virtually any Royal Navy ship to deploy a handful of Harriers. It was intended for the Skyhook to enable not only the launch and recovery of such aircraft, but to enable rapid rearming and refuelling operations to be performed. The system was marketed to various foreign customers into the 1990s, such as to enable Japan's fleet of helicopter destroyers to operate Harriers by installing the Skyhook on board. Perhaps the most elaborate implementation proposed was the application of the Skyhook to large submarines, such as the Russian , to produce a submarine aircraft carrier. The Saunders-Roe SR.A/1 was a prototype jet-propelled flying boat fighter, developed during the 1940s with the intention of eliminating the monopoly held by aircraft carriers on launching jet fighters. Described as being the first water-based aircraft to harness jet propulsion in the world, However, officials concluded that the concept had been rendered obsolete in comparison to increasingly capable land-based fighters, together with the inability to resolve engine difficulties, compelling a termination of work. During June 1951, the SR.A/1 prototype (TG263) flew for the last time. During the early 1950s, Saunders-Roe worked on a new fighter design, designated Project P.121, that featured skis aircraft publication Flight referred to it as the "Saunders-Roe Hydroski" with the aim of bringing its performance closer to that of land-based aircraft. By adopting hydroskis and dispensing with the hull approach of the SR.A/1, no concessions to hydrodynamic requirements were imposed upon the fuselage. The Convair F2Y Sea Dart was a supersonic seaplane jet fighter that had skis rather than wheels. In the late 1940s, the United States Navy feared that supersonic aircraft would stall at low speeds required for a carrier arresting gear, and therefore would not be able to land on a conventional aircraft carrier. The Sea Dart would land on (smooth) water; then be lowered and raised from the sea via crane. The Navy also considered combining the Sea Dart with the unorthodox approach of a submarine aircraft carrier that could carry up to three such aircraft inside purpose-built pressure chambers. They would have been raised by a portside elevator aft of the sail and either take off on their own from a smooth sea or be catapult launched from the aft in a higher sea. During the test flight phase, the hydro-skis generated violent vibrations during takeoff and landing, while a fatal crash caused by structural failure also marred the programme; the Navy opted to cancel all production aircraft. The United States Navy held considerable interest in the submarine aircraft carrier concept during the late 1940s. A study performed in 1946 envisioned very large submarines, ranging from to in length, to carry two XA2J Super Savage bombers for the strategic nuclear strike mission, or alternatively four F2H Banshee fighters. Another proposal would have involved the conversion of redundant Second World War-era fleet submarines to enable carriage and launch of a seaplane model of the Douglas A-4 Skyhawk attack aircraft, which would have been equipped with hydro-skis for takeoff similar to those of the Sea Dart. ==Tasks==

On US Navy aircraft carrier flight decks tasks are indicated by different jersey colors: ==See also==