There are a number of other claimants to the title "first railway in Britain", including the
Middleton Railway, the
Swansea and Mumbles Railway and the
Surrey Iron Railway amongst others.
Samuel Lewis in his 'A Topographical Dictionary of England' in 1848, called it the first railway in South of England. In 1823,
William James visited
Canterbury. He suggested to
Canterbury City Council that a railway to link Canterbury and the
Thames Estuary would help alleviate traffic problems in the city. The initial act of Parliament for the construction of the line, the '''''' (
6 Geo. 4. c. cxx), was passed on 10 June 1825. Three further acts in 1827, 1828 and 1835 allowed for the issue of a further £80,000 of stock. From the beginning, the Canterbury and Whitstable Railway was a public railway, intended for passengers as well as freight. Indeed, the world's first
season ticket was issued for use on the line in 1834, to take Canterbury passengers to the Whitstable beaches for the summer season. Unlike the
Liverpool and Manchester Railway which opened four months later, it used
cable haulage by stationary
steam engines over much of its length, with
steam locomotives restricted to the level stretch. Until the early 19th century, Canterbury's line of supply for goods had been along the
River Stour which flows to Pegwell Bay, near
Ramsgate on the eastern coast of Kent. Although this is only as the crow flies, the meandering river journey is around . The river was continually silting up, and the cost of dredging such a length was prohibitive. Although
turnpikes had been built, four or five
carts were needed to carry the load of a single barge. Whitstable, on the coast about due north, was at that time a small fishing village and port with a trade in
iron pyrites from the
Isle of Sheppey. The idea for the line came from
William James who surveyed the route and produced plans for improving the harbour. The immediate problem was that the land between Whitstable and Canterbury rose to a height of and railway haulage on steep gradients was technically very difficult at that time. The only alternative would have been a much longer route through Sturry, Herne and Swalecliffe and land acquisition would have been a major cost. Accordingly, the direct route was chosen, with three steep gradients, two of them to be worked by ropes from stationary steam engines at Clowes Wood and Tyler Hill. From Canterbury North Lane station, the line climbed for at 1 in 46 to Tyler's Hill, where there were two winding engines. At Tyler Hill, there was an tunnel. The gradient eased to 1 in 750 for a further to the summit of the line at Clowes Wood, where there was a winding engine. The line descended for at 1 in 31, followed by a level stretch of before another descent at 1 in 53 for and a final level section of into Whitstable, giving a total length of . Construction began in 1825 with
George Stephenson as the engineer, with the assistance of
John Dixon as resident engineer and
Joseph Locke in charge of track. In 1827, following the boring of Tyler Hill Tunnel, work stopped through a lack of funds.
Robert Stephenson took charge. Money was raised to enable the completion of the line. Dixon left the company, being replaced by Joshua Richardson. The promoters returned to Parliament three more times to obtain authorisation for the raising of additional funds, obtaining the '
(7 & 8 Geo. 4. c. xi), the (9 Geo. 4. c. xxix) and the ' (
5 & 6 Will. 4. c. lxxxii). The construction of Whitstable Harbour, under the direction of
Thomas Telford, was completed in 1832. The line finally opened on 3 May 1830, with a single track throughout and passing loops at Clowes Wood and the entrance to Tyler Hill tunnel. The track consisted of fish-bellied iron rails, laid on wooden sleepers at intervals, the more usual alternative of stone blocks being considered too expensive. Initially, Stephenson had recommended the use of stationary engines for the three inclines, with horses for the level sections. However, the promoters insisted on use of a locomotive for the least difficult incline, and
Invicta was procured from
Robert Stephenson and Company, and it was brought to Whitstable by sea. Unfortunately, the short gradient from Whitstable proved too much for it, and a third stationary engine was installed at Bogshole. The original Whitstable Harbour station was north Harbour Street at Whitstable harbour. This caused problems as trains standing at the station held up shunting operations. For the first few years after opening, passengers were carried in open wagons that formed
mixed trains. The line was visited by
Isambard Kingdom Brunel in 1835. The purpose of his visit was to conduct some experiments with a view to silencing some of the criticism he had received in relation to his proposals for the
Great Western Railway, particularly the perceived problems of working a tunnel on a steep gradient, which Brunel wished to do at
Box Tunnel. Also in 1835,
Invicta was modified in order to improve its performance. The modification was unsuccessful and led to the locomotive being taken out of service and trains being hauled only by the stationary engines. in 1838, the line was leased to Nicholson & Bayless. The C&WR tried to sell
Invicta in 1839 in order to clear some of its debts, but no buyer was found. In 1839, passenger services were five daily. Nicholson and Bayless went
bankrupt in 1841 and the line was advertised to let.
Invicta was later given to the Canterbury City Corporation, and for many years stood on a plinth in the Dane John Gardens beside the Riding Gate.
Invicta was then displayed, cosmetically restored, at the Canterbury Heritage Museum until 2018 when the museum closed. In 2019,
Invicta was moved to the Whitstable Museum and Gallery and is now on display there. == South Eastern Railway ==