General characteristics and machinery The ships of the
Habsburg class were 113.11 m (371 ft)
long at the waterline and 114.55 m (375 ft 10 in)
long overall. They had a
beam of 19.8 m (65 ft) and a
draft of 7.5 m (24 ft 6 in).
Freeboard was approximately forward and about aft. They displaced . The ships had a crew of 638 officers and enlisted men. The ships had a flush main deck that was planked with wood, while the upper decks were covered with
linoleum or
corticine. The hulls for each ship were constructed from transverse and longitudinal steel frames, over which the outer hull plates were
riveted. The hull incorporated a
double bottom that ran for 63% of its length. A series of watertight
bulkheads extended from the
keel to the gun deck; there were a total of 174
watertight compartments in each ship. The ships had a
metacentric height of between and .
Bilge keels were mounted on either side of the hull to reduce rolling. Their machinery system consisted of 2-shaft 4-cylinder vertical
triple expansion engines. They were supplied with steam by 16 Belleville
boilers.
Habsburgs powerplant was rated at , which produced a top speed of .
Árpáds system was slightly less efficient, at , though it achieved a comparable speed of on trials.
Babenberg had the most powerful engines of the three, which ran at and provided a top speed of .
Armament The ships' primary armament was three
L/40 guns, with two mounted in a twin
turret forward and one mounted in a single turret aft of the main superstructure. The guns were manufactured by
Krupp in Germany, and were the C 97 type. Secondary armament included twelve
SK L/40 guns in
casemates. They were mounted in an unusual arrangement: there were two decks of three guns each on either side amidships. These guns could fire armor-piercing shells at a rate of 4–5 per minute. The guns could depress to −7 degrees and elevate to 20 degrees, for a maximum range of . They were manually elevated and trained. The ships carried a wide array of smaller weapons, for defense against torpedo boats. These included ten Škoda 7 cm guns| L/45 guns, six QF 3-pounder Hotchkiss#Austro-Hungarian service| L/44 quick-firing (QF) guns, and two L/33 QF guns. All of these guns were emplaced in single mounts, either on the upper decks and superstructure, or in casemates at the bow and stern. With the exception of the main battery 24 cm weapons, all of the guns carried on the ships were manufactured by
Škoda Works in
Pilsen. The ships also carried two
Whitehead submerged
torpedo tubes.
Armor Habsburg and her sisters were protected by
face-hardened chrome-nickel steel. The main
armored belt was in the central portion of each ship, where the ammunition
magazines, machinery spaces, and other critical areas were located. The belt tapered slightly to on either end of the central section. Past the barbettes, the hull was protected by about of armor plate, up to the bow and stern. The entire belt, including the thinner portions forward and aft of the main battery barbettes, extended for below the
waterline and above. The belt was widened at the bow to cover the
ram. Side protection was supplemented by thick armor above the main belt; this section of armor extended up to meet the gun deck. The armored deck was thick. The main battery turrets were protected by armor plate that was thick on the sides and faces of the gun mounts. The armored barbettes that held the turrets, working chambers, and shell rooms were protected with of armor. The casemates for the 15 cm guns were on the outboard side and on the less vulnerable inboard side. The forward
conning tower was armored with sides that were thick and contained a thick communications tube; the aft conning tower was less well-protected. Its sides were 100 mm thick, and its communication tube was only 50 mm thick. == Construction ==