Preparation Preparation may begin three to seven days before surgery, with the pre-operative application of NSAIDs and antibiotic eyedrops. If the IOL is to be placed behind the iris, the pupil is
dilated by using drops to help better visualise the cataract.
Pupil-constricting drops are reserved for secondary implantation of the IOL in front of the iris, when the cataract has already been removed without primary IOL implantation. The operation may occur on a stretcher or a reclining examination chair. The eyelids and surrounding skin are swabbed with a disinfectant, such as 10%
povidone-iodine, and topical povidone-iodine is applied to the eye. The face is covered with a cloth or sheet with an opening for the operative eye. The eyelid is held open with a
speculum to minimize blinking during surgery. Pain is usually minimal in properly anaesthetised eyes, though a pressure sensation and discomfort from the bright operating microscope light is common.
Anaesthesia Most cataract operations are performed under
local anaesthetic, allowing the patient to return home the same day. Lens and cataract procedures are commonly performed in an outpatient setting; in the United States, 99.9% of lens and cataract procedures were done in an outpatient setting by 2012.
Topical,
sub-tenon,
peribulbar, or
retrobulbar local anaesthesia is generally used, usually causing little or no discomfort. Injections may be used to block regional nerves and prevent eye movement. Topical anaesthetics are most commonly used, placed on the
globe of the eye as eyedrops (before surgery), or in the globe (during surgery). Oral or
intravenous sedation to reduce anxiety may be combined with the local anaesthetic.
General anaesthesia and retrobulbar blocks were historically used for intracapsular cataract surgery, and may be used for children and adults whose medical or psychiatric issues significantly affect their ability to remain still during the procedure.
Phacoemulsification Phacoemulsification uses a machine with an
ultrasonic handpiece with a
titanium or
surgical stainless steel tip, which vibrates at an ultrasonic frequency—commonly 40
kHz—to emulsify the lens tissue, which is aspirated by a coaxial annular suction tube. A second instrument, which is sometimes called a "cracker" or "chopper", may be used from a small side incision to break the hard cataract nucleus into smaller pieces, making emulsification and removal of the soft part of the lens around the nucleus easier. After phacoemulsification of the lens nucleus and cortical material is completed, an irrigation–aspiration (I-A) system is used to remove the remaining peripheral lens material. The procedure is done under a surgical microscope.
Femtosecond laser-assisted phacoemulsification surgery is a more recent development which may have fewer adverse effects on the
cornea and
macula than manual phacoemulsification. The laser is used to make the corneal incision and the
capsulotomy, which provides access to the lens, and initiate lens fragmentation, which reduces energy requirements for phacoemulsification. It provides high-precision, effective lens fragmentation at lower power levels and consequent good optical quality. However, as of 2022, the technique has not been shown to have significant visual, refractive, or safety benefits over manual phacoemulsification, and it has a higher cost. Entry into the eye is made through a minimal tunnel incision near the edge of the cornea. The incision for cataract surgery has evolved along with the techniques for cataract removal and IOL placement. In phacoemulsification, the width depends on the requirements for IOL insertion. With foldable IOLs, it is often possible to use incisions smaller than . The shape, position, and size of the incision affect the capacity for self sealing, the tendency to induce astigmatism, and the surgeon's ability to maneuvre instruments through the opening. A more-posterior incision simplifies wound closure and decreases induced astigmatism, but it is more likely to damage
blood vessels nearby. One or two smaller side-port incisions at 60-to-90 degrees from the main incision may be needed to access the anterior chamber with additional instruments.
Ophthalmic viscosurgical devices (OVDs), a class of clear,
gel-like materials, are injected into the anterior chamber at the start of the procedure, to support, stabilize, and protect the eyeball, to help maintain eye shape and volume, and to distend the lens capsule during IOL implantation. Their consistency allows surgical instruments to move through them, although they do not flow and retain their shape under low
shear stress. The OVD will also constrain lens fragments from drifting around in the chamber. OVDs are available in several formulations, which may be combined or used individually as best suits the procedure. The lens is inside a capsule supported by the ciliary body, between the aqueous and vitreous, behind the opening in the iris.
Capsulorhexis is the process of tearing a circular opening in the front membrane of the lens capsule to access the lens within. In phacoemulsification, an anterior
continuous curvilinear capsulorhexis is usually used to create a round, smooth-edged opening through which the surgeon can emulsify the lens nucleus, and then implant the intraocular lens. The cataract's outer (cortical) layer is then separated from the capsule by a gentle, continuous flow or pulsed dose of liquid from a
cannula, which is injected under the anterior capsular flap, along the edge of the capsulorhexis opening, in a step called
hydrodissection. In
hydrodelineation, fluid is injected into the body of the lens through the cortex against the nucleus of the cataract, which separates the hardened nucleus from the softer cortex shell by flowing along the interface between them. As a result, the smaller hard nucleus can be more-easily emulsified. The posterior cortex serves as a buffer at this stage, protecting the posterior capsule membrane. The smaller size of the separated nucleus allows it to be broken up using shallower and less-peripheral grooving by the phaco tip, and produces smaller fragments after cracking or chopping. The posterior cortex also maintains the shape of the capsule through this stage, which reduces the risk of posterior capsule rupture. After nuclear cracking or chopping (if needed), the cataract is
reduced to small fragments using ultrasound which are simultaneously aspirated. The remaining lens cortex (outer layer of lens) material from the capsular bag is carefully aspirated, and if necessary, the remaining epithelial cells from the capsule are removed by
capsular polishing. The folded intraocular replacement lens is implanted, usually into the remaining posterior capsule, and checked to see that it has unfolded and seated correctly. A toric IOL must also be aligned in the correct axis to counteract astigmatism.
Manual small incision cataract surgery (MSICS) Many of the steps followed during MSICS are similar, if not identical, to those for phacoemulsification; the main differences are related to the alternative method of incision and cataract extraction from the capsule and eye.
Manual small incision cataract surgery (MSICS) is an evolution of extracapsular cataract extraction (ECCE); the lens is removed from the eye through a self-sealing tunnel wound through the sclera. A well-constructed scleral tunnel is held closed by internal pressure, is
watertight, and does not require suturing. The wound is relatively smaller than the one in ECCE, but is still markedly larger than a phaco wound. The small incision into the anterior chamber of the eye is made at or near the
corneal limbus, where the
cornea and
sclera meet, either
superior or
temporal. Advantages of the smaller incision include use of few-to-no stitches and shortened recovery time. The MSICS incision is small in comparison with the earlier ECCE incision, but considerably larger than the one used in phacoemulsification. The precise geometry of the incision is important, as it affects the self-sealing of the wound and the amount of astigmatism induced by distortion of the cornea during healing. A sclerocorneal or scleral tunnel incision is commonly used, since it reduces the risk of induced astigmatism if suitably formed. A sclerocorneal tunnel, a three-phase incision, starts with a shallow incision perpendicular to the sclera, followed by an incision through the sclera and cornea approximately parallel to the outer surface, and then a beveled incision into the anterior chamber. This structure provides the self-sealing characteristic, because internal pressure presses together the faces of the incision.
Bridle sutures may be used to help stabilize the eyeball during sclerocorneal tunnel incision, and during extraction of the nucleus and epinucleus through the tunnel. The depth of the anterior chamber and position of the posterior capsule may be maintained during surgery by OVDs or an anterior chamber maintainer, which is an auxiliary cannula providing a sufficient flow of
buffered saline solution (BSS) to maintain stability of the shape of the chamber and internal pressure. An anterior
capsulotomy, is then done to open the front surface of the lens capsule for access to the lens. The
continuous curvilinear capsulorhexis technique is often used, or
can-opener capsulotomy or
envelope capsulotomy. The lens may be divided into two or more pieces of similar size using a constricting loop, blades or other devices. The cataract lens or fragments are then removed from the capsule and anterior chamber using hydroexpression, viscoexpression, or more direct mechanical methods. Following cataract removal, an IOL is usually inserted into the posterior capsule. When the posterior membrane of the capsule is damaged, the IOL may be inserted into the ciliary sulcus, or a
glued intraocular lens technique may be applied.
Extracapsular cataract extraction (ECCE), also known as manual extracapsular cataract extraction, is the removal of almost the entire natural lens in one piece, while most of the elastic lens capsule (posterior capsule) is left intact to allow implantation of an intraocular lens. The lens is manually removed through a incision in the cornea or
sclera. Although it requires a larger incision and the use of stitches, this method may be preferable for very hard cataracts, which would require a relatively large ultrasonic energy input, which causes more heating, as well as in other situations in which phacoemulsification is problematic.
Converting to ECCE to manage a contingency The most commonly used procedures are phacoemulsification and manual small incision cataract surgery (MSICS). In either of these procedures, it can sometimes be necessary to convert to ECCE to deal with a problem better managed through a larger incision. This may occur in the event of posterior capsule rupture,
zonular dehiscence, a dropped nucleus with a nuclear fragment more than half the size of the cataract, problematic capsulorhexis with a hard cataract, or a very dense cataract where the heat developed by phacoemulsification is likely to cause permanent damage to the cornea. Similarly, a change from MSICS to ECCE is appropriate whenever the nucleus is too large for the MSICS incision, as well as in cases where the nucleus is found to be deformed during MSICS on a nanophthalmic eye.
Closing the wound After the IOL is inserted, OVDs that were injected to stabilize the anterior chamber, protecting the cornea from damage and distending the cataract's capsule during IOL implantation, are removed from the eye to prevent post-operative viscoelastic glaucoma, a severe intra-ocular pressure increase. This is done via suction from the irrigation-aspiration instrument and replacement by buffered saline solution (BSS). Cohesive OVDs tend to adhere to themselves, a characteristic that makes their removal easier. Removal of OVDs from behind the implant reduces the risk and magnitude of post-operative pressure spikes or capsular distention. In the final step, the wound is sealed by increasing the pressure inside the globe with BSS, which presses the internal tissue against the external tissue of the incision, holding it closed. The surgeon will check whether the incision leaks fluid, because wound leakage increases the risk of penetration into the eye by microorganisms, thus predisposing it to
endophthalmitis. If this does not achieve a satisfactory seal, a suture may be added. The wound is then hydrated, an antibiotic/steroid combination eyedrop is put in, and an eye-shield may be applied, sometimes supplemented with an eyepatch. ==Post-operative care==