Like other orientalosuchins
Jiangxisuchus possessed a short and blunt snout, which was initially likened to that of
Stangerochampsa. Like in other orientalosuchins and modern
crocodiles, a prominent notch is present where the
premaxilla, which form the tip of the snout, meet the
maxilla, which contains the majority of the toothrow of the upper jaw. As in modern crocodiles, this notch functions primarily to receive the enlarged fourth tooth of the dentary when the jaws are closed, separating the premaxillary from the maxillary teeth. This feature is among the characteristics that complicate the phylogenetic placement of orientalosuchins amongst crocodilians, as such a notch is generally thought to be a feature not seen in alligatoroids. This notch also contributes to the pronounced festooning of the jaw, the sinuous appearance of the dental margin created by convex and concave regions across the premaxilla and maxilla. While this festooning is not very visible when looking at the maxilla from above, a sideview reveals two bulging regions of the maxilla that peak with the fifth and eleventh tooth respectively. The external nares are described as oval and face anterodorsally (meaning they open upwards and towards the front) with a slightly elevated rim. This opening is almost entirely surrounded by the premaxillae except for a small section at the back where the strap-like
nasal bones insert themselves between the two halves to make their own contribution to the edge of the nares, even entering the opening slightly. Instead of joining one-another, each premaxilla forms a so-called premaxillary process that runs alongside the outer edges of the nasals until the level of the third maxillary tooth. The nasals stretch across the entire snout back of the nares until they meet the
frontal bone, which separates them and causes them to diverge into two pointed processes that are wedged between the frontal and the rhomboid
prefrontals to either side. The maxillae form the outer edges of the snout lateral to the nasals, maintaining a fairly consistent width from their contact with the premaxillae all the way back to where they contact the
lacrimals. There each maxilla forms a small process that briefly slides into the space between lacrimal and nasal while on the edge of the skull they narrow significantly until they contact the
jugal. The
eyesockets of
Jiangxisuchus were large, larger than any other of the skull openings, had raised rims and may have been topped by
palpebrals. The orbits were separated by the singular frontal bone. This bone can broadly be divided into the pointed anterior process that splits the nasals and a posterior region that contributes to the skull table, effectively briding the regions before and behind the eyes. Overall the surface of the frontal is described as flat, meaning that the edge of the eyesockets are not raised as is seen in some other crocodilians. The
skull table is a raised section of the skull located just behind the eyes and in addition to the frontal consists of the paired
postorbitals,
squamosals and a single
parietal bone. In
Jiangxisuchus the
supraoccipital is also exposed on the skull table. Between these bones lie the
supratemporal fossae, two openings fairly central on the structure separated by the parietal, which forms elevated rims around the openings. It is noted that between the fossae, the parietal is very narrow, much narrower than the space that separates the two eyesockets from each other. The postorbitals form the front corners of the skull table and form the upper part of the
postorbital bar, a peg-like bone that separates the eyesocket and the
infratemporal fenestra. Behind the eyesockets and below the skull table lie the infratemporal fenestra, separated from the former by the postorbital bar (formed by the jugal and postorbital). The jugal forms almost the entire lower edge of the fenestra before coming into contact with the
quadratojugal, which in addition to continuing horizontally also forms a so-called ascending process that forms the back edge of the infratemporal fenestra. Small parts of the fenestra are also formed by the squamosal and the quadrate, which additionally work together to form the otic recess. Looking at the skull from below reveals that the
incisive foramen, a hole close to the tip of the snout, is located noticeably further back from the tip than the external nares on the other side of the skull and entirely surrounded by the premaxillae, excluding the maxillae. Two other large openings in the underside of the cranium are the
suborbital fenestrae, which are separated by the
palatines which do not extend beyond the fenestrae. The
pterygoid bone is located behind the palatines and contains the
choana, yet another opening and divided by a septum. The pterygoid is in contact with the
ectopterygoid, which forms part of the outer and posterior margin of the suborbital fenestrae and is generally described as wide. Even the narrower "waist" of the ectopterygoid is wider than the narrowest point of the palatines. It participates in the pterygoid flange but does not extend to the very end of this structure. The mandibular symphysis, the region of the two halves of the lower jaw meet each other, is entirely formed by the
dentaries to the exclusion of the
splenial and described as being relatively short, ending just after the fifth tooth socket. Overall the lower jaw displays strong festooning corresponding with the upper jaw. The splenial forks at the back, contacting the
surangular and
angular bones as well as the
mandibular fenestra.
Dentition The dentition of the upper jaw consisted of five premaxillary and 14 maxillary teeth, separated from each other by a
diastema. Of the premaxillary teeth, the third was the largest, with the fourth and fifth being successively smaller and the first the smallest. In the maxillary toothrow, the fifth is the largest tooth, followed by the fourth and eleventh. The tooth size matches the festooning of the jaw, seeing an increase in size leading up to the fifth which marks the apex of the first convex region of the maxilla followed by a decrease leading to a concave area. A second increase of tooth size can be observed from the 8th to 11th tooth, corresponding to the second maxillary festoon. The upper jaw features two different tooth morphologies, with those in the premaxilla and the first nine maxillary teeth all being conical, unserrated and with a slight curvature to them. This changes with the tenth tooth, from which onward the teeth have a constricted base and low, bean-shaped
crowns. The lower jaw contained 19 teeth in total, with the preserved fourth tooth sharing its morphology with the fifth maxillary tooth. As is usual, the fourth dentary tooth is the largest of the lower jaw and alveolar size indicates that the twelfth would have been the second largest. There are several partial or complete bony septums that separate some of the teeth of the lower jaw and a diastema is present between the eighth and ninth dentary teeth. Occlusion of the teeth appears to have varied across the jaw. Occlusal pits are present medial to the first two premaxillary teeth, indicating an overbite in that region, but between the seventh and eight maxillary teeth, indicating interlocking of the teeth there. The enlarged fourth dentary tooth would have slid neatly into the notch present between the premaxilla and maxilla.
Postcrania A few postcranial elements are preserved, mostly due to being attached to the skull. These include several
vertebrae including one of the tail,
ribs, a
radiale and a few
osteoderms. Among the osteoderms is a single eliptical piece that lacks a crest. This would suggest that the osteoderm would in life have been part of the appendicular armor, meaning
Jiangxisuchus had armored limbs.
Size Jiangxisuchus is described as small to medium sized, something that appears to have been a trend among orientalosuchins. ==Phylogeny==