There are three principal methods of conveying a new ship from building site to water, only two of which are called "launching". The oldest, most familiar, and most widely used is the end-on launch, in which the vessel slides down an inclined
slipway, usually
stern first. With the side launch, the ship enters the water broadside. This method came into use in the 19th century on inland waters, rivers, and lakes, and was more widely adopted during World War II. The third method is
float-out, used for ships that are built in basins or
dry docks and then floated by admitting water into the dock.
Stern-first shipyard on 25 March 1943 Normally,
ways are arranged perpendicular to the shore line (or as nearly so as the water and maximum length of vessel allows) and the ship is built with its
stern facing the water. Where the launch takes place into a narrow river, the building slips may be at a shallow angle rather than perpendicular, even though this requires a longer slipway when launching. Modern slipways take the form of a reinforced concrete mat of sufficient strength to support the vessel, with two "barricades" that extend well below the water level taking into account
tidal variations. The barricades support the two launch ways. The vessel is built upon temporary cribbing that is arranged to give access to the hull's outer bottom and to allow the launchways to be erected under the complete hull. When it is time to prepare for launching, a pair of standing ways is erected under the hull and out onto the barricades. The surface of the ways is greased. (
Tallow and
whale oil were used as grease in sailing ship days.) A pair of sliding ways is placed on top, under the hull, and a launch cradle with bow and stern poppets is erected on these sliding ways. The weight of the hull is then transferred from the build cribbing onto the launch cradle. Provision is made to hold the vessel in place and then release it at the appropriate moment in the launching ceremony; common mechanisms include weak links designed to be cut at a signal and mechanical triggers controlled by a switch from the ceremonial platform. On launching, the vessel slides backwards down the slipway on the ways until it floats by itself.
Sideways Some slipways are built so that the vessel is side-on to the water and is launched sideways. This is done where the limitations of the water channel would not allow lengthwise launching, but occupies a much greater length of shore.
The Great Eastern designed by
Brunel was built this way, as were many
landing craft during
World War II. This method requires many more sets of ways to support the weight of the ship.
Air-bag Sometimes ships are launched using a series of inflated tubes underneath the hull, which deflate to cause a downward slope into the water. This procedure has the advantages of requiring less permanent infrastructure, risk, and cost. The airbags provide support to the hull of the ship and aid its launching motion into the water, thus this method is arguably safer than other options such as sideways launching. These airbags are usually cylindrical in shape with hemispherical heads at both ends. ==Traditions==