Australia Each of the
states and territories of Australia is responsible for monitoring air - quality and publishing data in accordance with the National Environment Protection (Ambient Air Quality) Measure (NEPM) standards. Each state and territory publishes air- quality data for individual monitoring locations, and most states and territories publish air -quality indexes for each monitoring location. Across Australia, a consistent approach is taken with air - quality indexes, using a simple linear scale where 100 represents the maximum concentration standard for each pollutant, as set by the NEPM. These maximum concentration standards are: The air quality index (AQI) for an individual location is simply the highest of the air quality index values for each pollutant being monitored at that location. There are six AQI bands, with health advice for each:
Canada Air quality in Canada has been reported for many years with provincial air - quality indices (AQIs). Significantly, AQI values reflect air quality management objectives, which are based on the lowest achievable emissions rate, rather than exclusive concern for human health. The
Air Quality Health Index (AQHI) is a scale designed to help understand the effect of air quality on health. It is a health protection tool used to make decisions to reduce short-term exposure to air pollution by adjusting activity levels during increased levels of air pollution. The Air Quality Health Index also provides advice on how to improve air quality by proposing a behavioral change to reduce the environmental footprint. This index pays particular attention to people who are sensitive to air pollution. It provides them with advice on how to protect their health during air quality levels associated with
low,
moderate,
high and
very high health risks. The AQHI provides a number from 1 to 10+ to indicate the level of health risk associated with local air quality. On occasion, when the amount of air pollution is abnormally high, the number may exceed 10. The AQHI provides a local air - quality current value as well as a local air quality maximums forecast for today, tonight, and tomorrow, and provides associated health advice.
China Hong Kong On December 30, 2013,
Hong Kong replaced the
Air Pollution Index with a new index called the
Air Quality Health Index. This index, reported by the
Environmental Protection Department, is measured on a scale of 1 to 10+, and considers four air pollutants: ozone; nitrogen dioxide; sulfur dioxide and particulate matter (including PM10 and PM2.5). For any given hour the AQHI is calculated from the sum of the percentage excess risk of daily hospital admissions attributable to the 3-hour moving average concentrations of these four pollutants. The AQHIs are grouped into five AQHI health risk categories with health advice provided:
Mainland China China's Ministry of Environmental Protection (
MEP) is responsible for measuring the level of
air pollution in China. As of January 1, 2013, MEP monitors daily pollution level in 163 of its major cities. The AQI level is based on the level of six atmospheric pollutants, namely
sulfur dioxide (SO2),
nitrogen dioxide (NO2), suspended particulates smaller than 10 μm in
aerodynamic diameter (PM10), suspended particulates smaller than 2.5 μm in
aerodynamic diameter (PM2.5),
AQI mechanics An individual score (Individual Air Quality Index, IAQI) is calculated using breakpoint concentrations below, and using same piecewise linear function to calculate intermediate values as the US AQI scale. and The final AQI value can be calculated either per hour or per 24 hours and is
the max of these six scores. and other websites. The
Central Pollution Control Board along with State Pollution Control Boards has been operating National Air Monitoring Programme (NAMP) covering 240 cities of the country, with more than 342 monitoring stations. An Expert Group comprising medical professionals, air quality experts, academia, advocacy groups, and SPCBs was constituted and a technical study was awarded to
IIT Kanpur. IIT Kanpur and the Expert Group recommended an AQI scheme in 2014. While the earlier measuring index was limited to three indicators, the new index measures eight parameters. The continuous monitoring systems that provide data on near real-time basis are installed in New Delhi,
Mumbai,
Pune,
Kolkata and
Ahmedabad. There are six NAQI categories, namely
Good,
Satisfactory,
Moderate,
Poor,
Severe and
Hazardous. The proposed NAQI will consider eight pollutants
PM10,
PM2.5,
NO2,
SO2,
CO,
O3,
NH3, and
Pb) for which short-term (up to 24-hourly averaging period) National Ambient Air Quality Standards are prescribed. Based on the measured ambient concentrations, corresponding standards and likely health effects, a sub-index is calculated for each of these pollutants. The worst sub-index reflects overall NAQI. Likely health effects for different NAQI categories and pollutants have also been suggested, with primary inputs from the medical experts in the group. The NAQI values and corresponding ambient concentrations (health breakpoints) as well as associated likely health effects for the identified eight pollutants are as follows:
Japan According to
Japan Weather Association, Japan uses a different scale to measure the air quality index.
Mexico The air quality in
Mexico City is reported in IMECAs. The IMECA is calculated using the measurements of average times of the chemicals ozone (O3), sulfur dioxide (SO2), nitrogen dioxide (NO2), carbon monoxide (CO), particles smaller than 2.5 micrometers (PM2.5), and particles smaller than 10 micrometers (PM10).
Singapore Singapore uses the
Pollutant Standards Index to report on its air quality, with details of the calculation similar but not identical to those used in Malaysia and Hong Kong. The PSI chart below is grouped by index values and descriptors, according to the
National Environment Agency.
South Korea The Ministry of Environment of South Korea uses the Comprehensive Air-quality Index (CAI) to describe the ambient air quality based on the health risks of air pollution. The index aims to help the public easily understand the air quality and protect people's health. The CAI is on a scale from 0 to 500, which is divided into six categories. The higher the CAI value, the greater the level of air pollution. Of values of the five air pollutants, the highest is the CAI value. The index also has associated health effects and a colour representation of the categories as shown below. The
N Seoul Tower on
Namsan Mountain in central
Seoul, South Korea, is illuminated in blue, from sunset to 23:00 and 22:00 in winter, on days where the
air quality in Seoul is 45 or less. During the spring of 2012, the Tower was lit up for 52 days, which is four days more than in 2011.
United Kingdom The most commonly used air quality index in the UK is the
Daily Air Quality Index recommended by the
Committee on the Medical Effects of Air Pollutants (COMEAP). This index has ten points, which are further grouped into four bands: low, moderate, high and very high. Each of the bands comes with advice for at-risk groups and the general population. The index is based on the concentrations of five pollutants. The index is calculated from the concentrations of the following pollutants: ozone, nitrogen dioxide, sulfur ioxide, PM2.5 and PM10. The breakpoints between index values are defined for each pollutant separately and the overall index is defined as the maximum value of the index. Different averaging periods are used for different pollutants. The AQI is based on the five "criteria" pollutants regulated under the
Clean Air Act: ground-level ozone, particulate matter, carbon monoxide, sulfur dioxide, and nitrogen dioxide. The EPA has established
National Ambient Air Quality Standards (NAAQS) for each of these pollutants in order to protect public health. An AQI value of 100 generally corresponds to the level of the NAAQS for the pollutant. To convert an air pollutant concentration to an AQI, EPA has developed a calculator. If multiple pollutants are measured at a monitoring site, then the largest or "dominant" AQI value is reported for the location. The ozone AQI between 100 and 300 is computed by selecting the larger of the AQI calculated with a 1-hour ozone value and the AQI computed with the 8-hour ozone value. Eight-hour ozone averages do not define AQI values greater than 300; AQI values of 301 or greater are calculated with 1-hour ozone concentrations. 1-hour SO2 values do not define higher AQI values greater than 200. AQI values of 201 or greater are calculated with 24-hour SO2 concentrations. Real-time monitoring data from continuous monitors are typically available as 1-hour averages. However, computation of the AQI for some pollutants requires averaging over multiple hours of data. (For example, calculation of the ozone AQI requires computation of an 8-hour average and computation of the PM2.5 or PM10 AQI requires a 24-hour average.) To accurately reflect the current air quality, the multi-hour average used for the AQI computation should be centered on the current time, but as concentrations of future hours are unknown and are difficult to estimate accurately, EPA uses surrogate concentrations to estimate these multi-hour averages. For reporting the PM2.5, PM10 and ozone air quality indices, this surrogate concentration is called the
NowCast. The Nowcast is a particular type of weighted average that provides more weight to the most recent air quality data when air pollution levels are changing.
Public availability of the AQI Real time monitoring data and forecasts of air quality that are color-coded in terms of the air quality index are available from EPA's AirNow web site. Other organizations provide monitoring for members of sensitive groups such as asthmatics, children and adults over the age of 65. Historical air monitoring data including AQI charts and maps are available at EPA's AirData website. There is a free email subscription service for New York inhabitants – AirNYC. Subscribers get notifications about the changes in the AQI values for the selected location (e.g. home address), based on air quality conditions. A detailed map containing current AQI levels and a two-day AQI forecast is available at the Aerostate web site.
Regulatory Air Monitors and Low Cost Sensors Historically, EPA has only allowed data from regulatory monitors operated by regulatory or public health professionals to be included in its real time national maps. In the past decade, low cost sensors (LCS's) have become increasingly popular with citizen scientists, and large LCS networks have sprung up in the US and across the globe. Recently, EPA has developed a data correction algorithm for a particular brand of PM2.5 LCS (the Purple Air monitor) that makes the LCS data comparable to regulatory data for the purpose of computing the AQI. This corrected LCS data currently appears alongside regulatory data on EPA's national fire map.
History of the AQI The AQI made its debut in 1968, when the National Air Pollution Control Administration undertook an initiative to develop an air quality index and to apply the methodology to
Metropolitan Statistical Areas. The impetus was to draw public attention to the issue of air pollution and indirectly push responsible local public officials to take action to control sources of pollution and enhance air quality within their jurisdictions. Jack Fensterstock, the head of the National Inventory of Air Pollution Emissions and Control Branch, was tasked to lead the development of the methodology and to compile the air quality and emissions data necessary to test and calibrate resultant indices. The initial iteration of the air quality index used standardized ambient pollutant concentrations to yield individual pollutant indices. These indices were then weighted and summed to form a single total air quality index. The overall methodology could use concentrations that are taken from ambient monitoring data or are predicted by means of a diffusion model. The concentrations were then converted into a standard statistical distribution with a preset mean and standard deviation. The resultant individual pollutant indices are assumed to be equally weighted, although values other than unity can be used. Likewise, the index can incorporate any number of pollutants although it was only used to combine
SOx,
CO, and TSP because of a lack of available data for other pollutants. While the methodology was designed to be robust, the practical application for all metropolitan areas proved to be inconsistent due to the paucity of ambient air quality monitoring data, lack of agreement on weighting factors, and non-uniformity of air quality standards across geographical and political boundaries. Despite these issues, the publication of lists ranking metropolitan areas achieved the public policy objectives and led to the future development of improved indices and their routine application.
Vietnam On November 12, 2019, Vietnam Environment Administration issued Decision No. 1459/QD-TCMT on promulgating Technical Guidelines for calculation and publication of Vietnam Air Quality Index (VN_AQI). ==See also==