Till

Till is a form of glacial drift, which is rock material transported by a glacier and deposited directly from the ice or from running water emerging from the ice. It is distinguished from other forms of drift in that it is deposited directly by glaciers without being reworked by meltwater. Till is characteristically unsorted and unstratified, and is not usually consolidated. Most till consists predominantly of clay, silt, and sand, but with pebbles, cobbles, and boulders scattered through the till. The abundance of clay demonstrates lack of reworking by turbulent flow, which otherwise would winnow the clay. Typically, the distribution of particle sizes shows two peaks (it is bimodal) with pebbles predominating in the coarser peak. Clasts in till may also show slight imbrication, with the clasts dipping upstream. Early researchers tended to prefer the term boulder clay for the same kind of sediments, but this has fallen into disfavor. Where it is unclear whether a poorly sorted, unconsolidated glacial deposit was deposited directly from glaciers, it is described as diamict or (when lithified) as diamictite. Tillite is a sedimentary rock formed by lithification of till. ==Processes==

Erosional Glacial till is mostly derived from subglacial erosion and from the entrainment by the moving ice of previously available unconsolidated sediments. Bedrock can be eroded through the action of glacial plucking and abrasion, and the resulting clasts of various sizes will be incorporated to the glacier's bed. Much of the silt in till is produced by glacial grinding, The deposition of glacial till is not uniform, and a single till plain can contain a wide variety of different types of tills due to the various erosional mechanisms and location of till with respect to the transporting glacier. Till is deposited as the terminal moraine, along the lateral and medial moraines and in the ground moraine of a glacier, and moraine is often conflated with till in older writings. Till may also be deposited as drumlins and flutes, though some drumlins consist of a core of stratified sediments with only a cover of till. Interpreting the glacial history of landforms can be difficult due to the tendency of overprinting landforms on top of each other. As a glacier melts, large amounts of till are eroded and become a source of sediments for reworked glacial drift deposits. These include glaciofluvial deposits, such as outwash in sandurs, and as glaciolacustrine and glaciomarine deposits, such as varves (annual layers) in any proglacial lakes which may form. Erosion of till may take place even in the subglacial environment, such as in tunnel valleys. ==Types of till==

There are various types of classifying tills: • Primary deposits – Laid down directly by glacier action.) a further set of divisions has been made to primary deposits, based upon the method of deposition. Van der Meer et al. 2003 have suggested that these till classifications are outdated and should instead be replaced with only one classification, that of deformation till. The reasons behind this are largely down to the difficulties in accurately classifying different tills, which are often based on inferences of the physical setting of the till rather than detailed analysis of the till fabric or particle size. Subglacial till Lodgement till Subglacial lodgement tills are deposits beneath the glacier that are forced, or "lodged" into the bed below. As glaciers advance or retreat, the clasts that are deposited by the ice may have a lower velocity than the ice itself. When the friction between the clast and the bed exceeds the forces of the ice flowing above and around it, the clast will cease to move, and it will become a lodgement till. Meltout till Subglacial meltout tills are tills that are deposited via the melting of the ice lobe. Clasts are transported to the base of the glacier over time, and as basal melting continues, they are slowly deposited below the glacier. Since the rate of deposition is controlled by the rate of basal melting, it is worth considering the factors that contribute to melting. These can be the geothermal heat flux, frictional heat generated by sliding, ice thickness, and ice-surface temperature gradients. Deformation till Subglacial deformation tills refer to the homogenization of glacial sediments that occur when the stresses and shear forces from the moving glacier rework the topography of the bed. These contain preglacial sediments (non glacial or earlier glacial sediments), which have been run over and thus deformed by meltout processes or lodgement. The constant reworking of these deposited tills leads to a highly homogenized till. ==Tillite==

In cases where till has been indurated or lithified by subsequent burial into solid rock, it is known as the sedimentary rock tillite. Matching beds of ancient tillites on opposite sides of the south Atlantic Ocean provided early evidence for continental drift. The same tillites also provide some support to the Precambrian Snowball Earth glaciation event hypothesis. ==Economic resources==

Tills sometimes contain placer deposits of valuable minerals such as gold. Diamonds have been found in glacial till in the north-central United States and in Canada. Till prospecting is a method of prospecting in which tills are sampled over a wide area to determine if they contain valuable minerals, such as gold, uranium, silver, nickel, or diamonds, and the flow direction indicated by the till is then used to trace the minerals back to their bedrock source. ==See also==