(May 1981)
Canada (May 2012) Rafting was a principal method of transporting timber in the southeastern United States but, except on the
Mississippi River, rafts were necessarily smaller than those described above. On Georgia's
Altamaha River, for example, the maximum width was about , that being the widest that could pass between the pilings of railroad bridges. Maximum length was about , that being the longest that could navigate The Narrows, several miles of the river that were not only very narrow but also very crooked. Each raft had two oars forty to fifty feet long, one in the bow, the other at the stern. The oars were for steering, not propelling, the raft. The minimum raft crew was two men, the pilot who usually manned the stern oar, and his bow hand. Rafts usually had a lean-to shack for shelter and a mound of dirt for a hearth to warm by and cook on. The timber rafts on the Altamaha delivered logs to the port of
Brunswick, Georgia, where they were loaded onto timber schooners and transported to international markets like
Liverpool,
Rio de Janeiro, and
Havana. Rivermen assigned colorful names to the various features and hazards along their route down the Atamaha. Among the many "riverman monikers" was
Old Hell Bight, where the river marks the border between
Long County to the north and
Wayne County to the south, and is a particularly troublesome bend, with associated dangerous currents, where a pilot and crew might lose "their wages, their timber, and occasionally their lives" Most rafts were sharp-chute, that is, V-bowed, rather than square-bowed. Raftsmen had learned that with a V-bow a raft was more likely to hold together and glance off if it drifted out of control and hit the river bank. As one old-time raftsman put it: “With a square bow you were compelled to hold the raft in or near the middle of the river: if it butted the hill it would come to pieces. The sharp-chute could be put together so it would not come apart. And it saved a lot of hard work. Raftsmen didn't mind letting it go to the hill. They’d say: ‘Let’er shoot out.’” Rafts were assembled in sections. Each section was made up of round or squared timbers, all of the same length except for the outside, or “boom logs,” which extended aft a few feet to enclose the following section. Thus the sections were coupled together. A fairly typical raft would be one of three, four or five sections, each section having timbers twenty to thirty feet in length. Most rafts were made up of squared timbers, either hewn square by hand or sawn square by upcountry sawmills. Some timbers were carefully, smoothly hewn, and there was a demand for them, especially in England, after steam sawmilling became common. On the Altamaha, for many years during the rafting era, most rafts were made up of “scab” timber, that is, logs roughly squared by broad ax for tighter assembly and for gang sawmills which could cut flat-face timber only. Although, on the Altamaha, there was rafting to some extent before the Civil War and after World War I, the Altamaha's rafting era is generally considered to have been the years between those wars. During those years,
Darien, a town at the mouth of the river with a population of perhaps a couple of thousand, was a major international timber port. Reports of exports from Darien were included in the New York Lumber Trade Journal along with reports of exports from such large ports as New Orleans, Mobile, Jacksonville, Savannah, Charleston, and Norfolk. ==In Quebec==