Rural Electrification Act

On May 11, 1935, President Roosevelt issued Executive Order 7037, which created the Rural Electrification Administration. In 1936, the Congress endorsed Roosevelt's action by passing the Rural Electrification Act. At the time the Rural Electrification Act was passed, electricity was commonplace in cities but largely unavailable in farms, ranches, and other rural places. Representative John E. Rankin and Senator George William Norris were supporters of the Rural Electrification Act, which was signed into law by Roosevelt on May 20, 1936. Speaker of the House Sam Rayburn was a major proponent of the REA, which he helped pass in 1936 as Chairman of the House Interstate and Foreign Commerce Committee. Rayburn stated in 1959 that ninety percent of farm homes in the U.S. were electrified, compared to three percent in the early 1930s. ==Criticism and Technical issues==

Historians Richard F. Hirsh and David T. Beito have criticized the REA for stifling the growth of more decentralized non-governmental sources of power. According to Beito, "the REA, and the TVA before it, reduced incentives for consumers to “stay off the grid.” At the time those agencies came on the scene, more than half of all electrified farm homes had individual generators. Manufactured by commercial companies and sold directly to consumers, these so-called “individual lighting plants” used such diverse power sources as wind, water, gasoline, or kerosene." Supporters of the REA argued that the provision of power to remote areas was not economically feasible. A 2300-volt distribution system was then used in cities. This relatively low voltage could be carried only about before the voltage drop became unacceptable. REA cooperatives used a 6900-volt distribution network (soon changed to the present-day 12,470/7200V 4-wire Y system), which could support much longer runs (up to about ). Despite requiring more expensive transformers at each home, the overall system cost was manageable. In opposition to this view, Beito notes that "Private companies had led a four-fold increase in electrification, some of which occurred during a so-called “agricultural depression” between 1924 (2.8 percent of rural homes) and 1932 (11.8 of rural homes). Had this original rate of increase continued (it slowed but did not decline during the early 1930s) nearly all farms would have been electrified by the 1940s."" ==Wiring homes and farms==

REA crews traveled through the American countryside, bringing teams of electricians along with them. The electricians added wiring to houses and barns to utilize the newly available power provided by the line crews. A standard REA installation in a house (post-World War II) consisted of: • A 60-amp, 230-volt fuse panel, with: • A 60-amp range circuit • A 20-amp kitchen circuit • Two or three 15-amp lighting circuits A ceiling-mounted light fixture was installed in each room, usually controlled by a single switch mounted near a door. At most, one outlet was installed per room, since plug-connected appliances were expensive and uncommon. Wiring was performed using type NM (nonmetallic sheathed cable), insulated with asbestos-reinforced rubber covered with jute and tar. Many of these original installations still exist today, though most have been augmented to support a greater number and variety of appliances. ==Later amendments==

Some amendments to the Rural Electrification Act include: • 1944: loan terms increased to 35 years; the act is made permanent • 1949: extended the act to allow loans to telephone companies wishing to extend their connections to unconnected rural areas • 1993: provisions to restructure the direct loan programs for rural electricity, telephone cooperatives, and energy conservation market • December 8, 1993: North American Free Trade Agreement Implementation Act—The "Buy American" provision to now include Mexico and Canada. • 2008: provisions for access to rural broadband telecommunications network and rural internet • 2014: pilot program for rural gigabit broadband network ==See also==