Thermal-driven outflow The simplest system for star lifting would increase the rate of solar wind outflow by directly heating small regions of the star's atmosphere, using any of a number of different means to deliver energy such as
microwave beams,
lasers, or
particle beams – whatever proved to be most efficient for the engineers of the system. This would produce a large and sustained eruption similar to a
solar flare at the target location, feeding the solar wind. The resulting outflow would be collected by using a
ring current around the star's equator to generate a powerful
toroidal magnetic field with its
dipoles over the star's rotational poles. This would deflect the star's solar wind into a pair of jets aligned along its rotational axis passing through a pair of magnetic rocket
nozzles. The
magnetic nozzles would convert some of the plasma's thermal energy into outward velocity, helping cool the outflow. The ring current required to generate this magnetic field would be generated by a ring of
particle accelerator space stations in close orbit around the star's equator. These accelerators would be physically separate from each other but would exchange two counterdirected beams of oppositely charged
ions with their neighbor on each side, forming a complete circuit around the star.
"Huff-n-Puff" David Criswell proposed a modification to the polar jet system in which the magnetic field could be used to increase solar wind outflow directly, without requiring additional heating of the star's surface. He dubbed it the "Huff-n-Puff" method, inspired from the Big Bad Wolf's threats in the fairy tale of
Three Little Pigs. In this system the ring of particle accelerators would not be in orbit, instead depending on the outward force of the magnetic field itself for support against the star's gravity. To inject energy into the star's atmosphere the ring current would first be temporarily shut down, allowing the particle accelerator stations to begin falling freely toward the star's surface. Once the stations had developed sufficient inward velocity the ring current would be reactivated and the resulting magnetic field would be used to reverse the stations' fall. This would "squeeze" the star, propelling stellar atmosphere through the polar magnetic nozzles. The ring current would be shut down again before the ring stations achieved enough outward velocity to throw them too far away from the star, and the star's gravity would be allowed to pull them back inward to repeat the cycle. A single set of ring stations would result in a very intermittent flow. It is possible to smooth this flow out by using multiple sets of ring stations, with each set operating in a different stage of the Huff-n-Puff cycle at any given moment so that there is always one ring "squeezing". This would also smooth out the power requirements of the system over time.
Centrifugal acceleration An alternative to the Huff-n-Puff method for using the toroidal magnetic field to increase solar wind outflow involves placing the ring stations in a polar orbit rather than an equatorial one. The two magnetic nozzles would then be located on the star's equator. To increase the rate of outflow through these two equatorial jets, the ring system would be rotated around the star at a rate significantly faster than the star's natural rotation. This would cause the stellar atmosphere swept up by the magnetic field to be flung outward. This method suffers from a number of significant complications compared to the others. Rotating the ring in this manner would require the ring stations to use powerful rocket thrust, requiring both large
rocket systems and a large amount of
reaction mass. This reaction mass can be "recycled" by directing the rockets' exhausts so that it impacts the star's surface, but harvesting fresh reaction mass from the star's outflow and delivering it to the ring stations in sufficient quantity adds still more complexity to the system. Finally, the resulting jets would spiral outward from the star's equator rather than emerging straight from the poles; this could complicate harvesting it, as well as the arrangement of the
Dyson sphere powering the system. ==Harvesting lifted mass==