These tests may be as simple as urinating behind a curtain while a doctor listens, but are usually more extensive in western medicine. A typical urodynamic test takes about 30 minutes to perform. It involves the use of a small catheter used to fill the bladder and record measurements. What is done depends on what the presenting problem is, but some of the common tests conducted are; • Post-void residual volume: Most tests begin with the insertion of a urinary catheter/transducer following complete bladder emptying by the patient. The urine volume is measured (this shows how efficiently the bladder empties). High volumes (180 ml or above) may be associated with
urinary tract infections. A post-void residual urine volume of greater than 50 ml in children has been described. High levels can be associated with
overflow incontinence. • The urine is often sent for microscopy and culture to check for infection. • Uroflowmetry: Free uroflowmetry measures how fast the patient can empty his/her bladder. Pressure uroflowmetry again measures the rate of voiding, but with simultaneous assessment of bladder and rectal pressures. It helps demonstrate the reasons for difficulty in voiding, for example bladder muscle weakness or obstruction of the bladder outflow. • Multichannel
cystometry: measures the pressure in the rectum and in the bladder, using two pressure catheters, to deduce the presence of contractions of the bladder wall, during bladder filling, or during other provocative maneuvers. The strength of the urethra can also be tested during this phase, using a cough or
Valsalva maneuver, to confirm genuine stress incontinence. • Urethral pressure profilometry: measures strength of sphincter contraction. •
Electromyography (EMG) measurement of electrical activity in the
bladder neck. • Assessing the "tightness" along the length of the urethra. •
Fluoroscopy of the bladder and urethra during voiding. ==Standardization==