The Tianjin Xingang
Fairway is divided into the Main Shipping Channel, the Chuanzhadong Channel, and the Northern Branch Channel. The Dagusha Channel and the Haihe river channel are separate fairways with slightly different regulations.
Shipping channels • The
Main shipping channel (新港主航道) is 39.5 km long. The channel extends from the gate line of the VTS control area (20 nautical miles (37 km) from the VTS control tower), up to the start of the Chuanzhadong Channel. Since November 2010, the Main Channel has been dredged to a depth of −19.5 m and a bottom width of 420 m, making it capable of handling two-way 250,000 DWT traffic, and to accept 300,000 DWT ships at high tide. There are two service channels (100 m wide and 9 m deep) at each side of the main channel, which allow ships under 10,000 DWT (i.e. service craft, barges and coastal ships) to transit without interference from the big ships. The breakwater mouth was expanded to 1,100 m wide in 2010. As of 2012, the Main Channel is being deepened to 22 m and widened to 765 m, which will allow two-way all-tide traffic of 300,000 DWT ships by 2013. • The
Chuanzhadong channel (船闸东航道), called "Chuanzha channel" in Admiralty charts, starts roughly at the level of the Second Pier and ends at the Xingang Shipping Lock, a total of around 4.5 km. Its depth varies between 10 m to 5 m as it approaches the shiplock. • The
Northern Harbor Branch Channel (北港支航道) extends from its bifurcation from the main channel up to the northern end of the basin, approximately 6.5 km. It has been dredged all the way to the end of the basin (where the Huicheng terminal lies) to a depth of 15 m and a width of between 190 m to 390 m. Its junction with the Main Channel was widened to 765 m in 2007 to facilitate traffic merging. The
Dagusha Channel (大沽沙航道) is wholly separate from the Main Channel. It is 27.5 km long from safe water (12 m isobath) to the mouth of the Haihe. It was upgraded in December 2010 to a depth of 12.3 m, 180 m wide, for a one-way traffic capacity of 50,000 DWT (100,000 DWT in high tide). Current dredging is expanding the Channel to 230 m bottom width and 14 m depth, which will allow all-tide traffic of 100,000 DWT vessels. The long-term plan is to dredge the Channel up to a two-way 200,000 DWT capability. The
Haihe River Channel varies in depth between 4 m to 8 m with a minimum bottom width of 50 m and a maximum of 120 m. It can handle vessels of up to 5,000 DWT in the section between the Xingang Shiplock and the
Haimen Bridge, and up to 3,000 DWT and 31 m air draft from the Haimen Bridge to the Second Tidal Barrier. This capacity will be reduced to 1,000 DWT once the planned fixed bridges in the Haihe are built. The
Beitangkou Channel (北塘口航道) is at present a natural shallow-water buoyed channel capable of handling barges, fishing boats and service vessels of up to 1,000 gt. It is currently being dredged to 7.9 m depth, 190 m width. The channels serving the other three port areas are being expanded and will become open as said areas become open. The
Nangang Channel was activated in July 2011 on a trial basis. At present it extends 19 km and is dredged to a 5,000 DWT capacity (100 m wide, 6.5 m deep). According to plans, it will reach 100,000 DWT capacity by as early as 2015. The
Gaoshaling Channel is currently being dredged to 12.5 m depth, 150 m width, for a planned capacity of 50,000 DWT in 2015. The
Hangu Channel is being dredged for 16 km to a 7 m depth, 75 m width, for a capacity of 5,000 DWT A number of secondary channels have been set up and seamarked by the
MSA and
FLEC to divert small boat traffic away from the main fairways. The "Sand and Gravel Transport Boats Preferred Channel" (天津港砂石运输船舶推荐航路) runs to the south of the Main Channel and the Dagukou anchorages, and is designed to stop the dangerous flow of barges and construction vessels that used to cut across NE-SW, right through the flow of large ships. The Donggu Fishing Port Channel runs north of the Dagusha Channel, close to the Nanjiang island, and separates fishing boats from the deep water channel.
Harbor basins are
breakwater-protected, and include the in-harbor Channels and the approaches to the wharves. The
Main Harbor Basin extends 16.5 km from the Xingang Shipping Lock to breakwater mouth, and there are four secondary basins within the main basin, formed by the four jutting
piers of the Beijiang port area. The
North Harbor Basin is 8.5 km long by 1,100–900 m wide, and has two secondary basins (in construction). The
Dagukou Harbor Basin is 14 km long, and tapers down from 1,500 to 900 m wide as it goes up the old Haihe mouth. It also has two secondary basins (in construction).
Anchorages Tianjin Port has six main anchorage areas and two temporary anchorages. All anchorages are designated for all functions—berth waiting, quarantine, inspection and pilotage—, and provide little shelter from weather or rough seas. Bottom hold is poor to very poor, anchored vessels are advised to keep five
cables of clearance, as anchor dragging is common (up to 5–10 NM in a day in winter, due to drifting ice). The Dagukou North, South and Chemical Bulk anchorages are situated on both sides of the main shipping channel, to the east of the Dagu Lighthouse. These anchorages cater for the majority of the traffic, and can get very crowded. Collisions have occurred with some frequency in the past. The two deep water anchorage sites are further out into the deeper parts of the Bohai Bay. One anchorage for very large
Capesize vessels of more than 150,000 DWT is shared with
Tangshan Caofeidian. Two more anchorages (No5 and 6) serve the Dagukou area. Both are located on the south side of the Dagusha channel. No6 covers 40 km2, has depth of 10–13 m and anchors small and medium displacement vessels. No5 anchorage covers 20 km2 and has a depth of 16–18 m, anchoring larger vessels. No6 anchorage is operational but still little used, No5 was recently activated (2011) but it is still considered "temporary". The most recent temporary anchorage serves the newly opened (2011) Nangang area. Finally, there is a "Zhengjiatai Lay-By Berthing Area" (郑家台临时候泊区) on the Haihe, next to the Second Barrier for ships awaiting berths at the Zhengjiatai terminal.
Shiplocks and tidal barriers The Haihe river channel is separated from the sea channels by three structures: First, the
Xingang Shiplock () in the northern side of the estuary is the main shipping route into the Haihe area. It was started by the
Japanese occupation forces in 1942, completed in 1943 and made operational by the Nationalist government after the war, in 1946. It has a width of 20.5 m, a length of 180 m and
cill depth of 5 m. It allows passage to vessels up to 18.5 m wide, limited to 17.5 m at night and for ships carrying liquid bulk or otherwise dangerous cargoes. The
Haihe Bridge is directly over the shiplock, with an air clearance of 39.5 m. Second, the
Haihe Tidal Barrier (), built in 1958, and last refurbished in 1999, serves as a dam,
flood control sluice and tide surge protection for the Haihe river mouth. It is an
open sluice design, with 8 vertical-rising gates designed for an average flow of 1,200 m3/s flow when open, with a maximum flow of 1,689 m3/s recorded on 28 August 1963. Third, the
Tanggu Fishing Boat Lock () is located at the western end of the channel between
Donggu and
Lanjingdao Island. Built in 1959, it is 150 m long, 14 m wide, 8 m ditch depth, with cill water depth of 2.5 m. It can handle ships of up to 200
gt. In 2011, the Fishing Boat Lock gates started to be rebuilt to allow for larger road traffic between Donggu and Lanjingdao. The final hydraulic structure of the Tianjin Port is the
Haihe Second Barrier () at Dongnigucun, in the
Jinnan district. The Second Barrier is also an open-type sluice barrier, with 8 vertical-rising gates allowing an average flow of 1200 m3/s. The Barrier, opened in July 1984, closes ship traffic upriver into Tianjin city proper, and its erection resulted in the abandonment of 29.3 km of navigable channel. == Port areas under development ==