Alpine Fault

The Pacific plate and Indo-Australian plate boundary forms the Macquarie Fault Zone in the Puysegur Trench off the southwestern corner of the South Island and comes onshore as the Alpine Fault just north of Milford Sound. The Alpine Fault then runs the length of the South Island just west of the Southern Alps to near Lewis Pass in the central northern section of the island. At this point, it splits into a set of smaller faults known as the Marlborough fault system. This set of faults, which includes the Wairau Fault, the Hope Fault, the Awatere Fault, and the Clarence Fault, transfer displacement between the Alpine Fault and the Hikurangi subduction zone to the north. The Hope Fault is thought to represent the primary continuation of the Alpine Fault. == Tectonics ==

The Australian plate, which is in the process of again separating from the Indo-Australian plate, is subducting towards the east south of the South Island and the Pacific plate is subducting towards the west to the north. In the middle, the Alpine Fault is a transform boundary and has both dextral (right-lateral) strike-slip movement and uplift on the southeastern side. The uplift is due to an element of convergence between the plates, meaning that the fault has a significant high-angle reverse oblique component to its displacement. In the northern section of the fault the transition to the Marlborough Fault System reflects transfer displacement between the mainly transform plate boundary of the Alpine fault and the mainly destructive boundary further northwards from the Hikurangi Subduction Zone to the Kermadec Trench. This has resulted in a complex splaying of faults, which is associated with large earthquakes adjacent to, but off the Alpine fault itself, such the 1929 Murchison earthquake, 1968 Inangahua earthquake and 1929 Arthur's Pass earthquake. The Alpine Fault has the greatest uplift of the Pacific plate near Aoraki / Mount Cook in its central section. Here the relative motion between the two plates averages 37–40 mm a year. This is distributed as 36–39 mm of horizontal and 6–10 mm upwards movement on the fault's plane per year. At the southern end of the fault there is effectively no uplift component of the Pacific plate and other faults share the strain as a result of the plate collision. These include in Fiordland faults associated with the 2003 Fiordland earthquake and 2009 Dusky Sound earthquake, the Otago fault system, in Canterbury faults such as the Ostler Fault Zone and those associated with the 7.1 MW Darfield earthquake. The uplift in this South Westland region of the fault which has a dextral strike-slip rate of about /year is on the Australian plate side of it with meter scale vertical uplift every 290 years odd. == Geological origin and evolution ==

in green, within the Alpine Fault zone, Waikukupa River.|alt= and breccia, Waikukupa River.|alt=Between 25 and 12 million years ago the movement on the proto-Alpine Fault was exclusively strike-slip. The Southern Alps had not yet formed and most of New Zealand was covered in water. Near the surface, the fault can have multiple rupture zones. == Fault zone geology ==

The fault zone is exposed at numerous locations along the West Coast, and typically consists of a 10 to 50 m wide fault gouge zone although the temperature of the water at depth is much more extreme. Most of the movement along the fault occurs in this zone. In outcrop, the fault zone is overlain by mylonites which formed at depth and have been uplifted by the fault. A structural study of a segment of the Alpine Fault to the southwest of Fiordland examined the Dagg Basin, an offshore sedimentary basin at depth. Basin sediments are primarily from Pleistocene glaciation, and structures within them reveal a past complexity that is no longer present in the basin. The current structure is a pull-apart basin along a releasing bend in the Alpine Fault, with a segment of inverted basin along the southern edge due to transpression. The study discussed the short-lived nature of the releasing bend (on the order of 10 to 10 years), during which there were 450 – 1650 m of dextral displacement. The nature of the displacement served as an example of the kinds of ephemeral structures that can develop along a mature strike-slip fault system. == Earthquakes ==

There have been no major historical earthquakes on the Alpine Fault. Because of this, during the mid-20th century it was speculated that the Alpine Fault creeps without making large earthquakes. However, it is now inferred by multiples lines of evidence that the Alpine Fault ruptures, creating major earthquakes approximately every few hundred years. The last whole fault rupture event was in 1717 and is now known to have been a great () earthquake of ± 0.1. Prehistoric Māori arrived in New Zealand about 1300 but never reached a high population density in the colder South Island. Therefore, while earthquakes are an important part of Māori oral tradition, no stories have been passed down about South Island earthquakes. Over the last thousand years, the major ruptures along the Alpine Fault, causing earthquakes of about magnitude 8 had previously been determined to have occurred at least four times. These had separation of between 100 and 350 years. Newer research carried out by the University of Otago, the Australian Nuclear Science and Technology Organisation and others has revised the dates and nature of the earthquakes and given greater understanding of their number. Studies at Haast towards the centre of the fault only identified three major rupture events in the last 1000 years. Studies at the far southern end identified seven events in the last 2000 years and the most southern of the fault has had 27 events since 6000 BCE. In 2017, GNS researchers revised the figures after they combined updated Hokuri site records with a thousand-year record from another site, 20 km away at John O'Groats River, to produce a record of 27 major earthquake events during the 8000-year period. A 2018 study says that a significant rupture in the Alpine Fault could lead to roads (particularly in or to the West Coast) being blocked for months, as with the 2016 Kaikōura earthquake, with problems in supplying towns and evacuating tourists. District councils along the West Coast and in Canterbury have commissioned studies and begun preparations for an anticipated large earthquake on the Alpine Fault. == History of research ==

In 1940, Harold Wellman found that the Southern Alps were associated with a fault line approximately 650 km (400 miles) The fault was officially named the Alpine Fault in 1942 as an extension of a previously mapped structure. At the same time, Harold Wellman proposed the lateral displacement on the Alpine Fault. This displacement was inferred by Wellman due in part to the similarity of rocks in Southland and Nelson on either side of the Alpine Fault. Lateral displacements of this magnitude could not be explained by pre-plate tectonics geology and his ideas were not initially widely accepted until 1956. Wellman also proposed in 1964 that the Alpine Fault was a Cenozoic structure, which was in conflict with the older Mesozoic age accepted at the time. This idea coupled with the displacement on the fault proposed that the earth's surface was in relatively rapid constant movement and helped to overthrow the old geosynclinal hypothesis in favour of plate tectonics. Richard Norris and Alan Cooper from the Department of Geology, University of Otago conducted extensive research on the structure and petrology of the Alpine Fault respectively throughout the later 20th and early 21st centuries. It was during this time that the cyclicity of the Alpine Fault earthquakes and meaning of the increase in metamorphic grade towards the fault was discovered and refined. Originally this regional increase in grade was inferred to be from frictional heating along the fault not uplift of deeper geological sequences. Richard H. Sibson from the same university also used the Alpine Fault to refine his nomenclature of fault rocks which gained international adherence. Chorus's dark fibre cables that pass through the Alpine Fault, from the north and south of Haast, are used for distributed acoustic sensing, which detects cable movement produced by earthquakes. Measurements are made using 7,250 'interrogator' locations, spaced four metres apart, which emit and detect pulses of light, generating about a gigabyte of data per minute. Deep Fault Drilling Project The Deep Fault Drilling Project (DFDP) was an attempt in 2014 to retrieve rock and fluid samples and make geophysical measurements inside the Alpine Fault zone at depth. It was a $2.5 million international research project designed to drill 1.3 km to the fault plan in two months. One of the goals of the project was to use the deformed rocks from the fault zone to determine its resistance to stress. In 2017, they reported they had discovered beneath Whataroa, a small township on the Alpine Fault, "extreme" hydrothermal activity which "could be commercially very significant". One of the lead researchers said that it is likely to be globally unique. ==See also==