The basic Cymbeline was a single unit on a turntable stand with four adjustable legs for levelling. The main elements were the antenna, the Foster scanner, the main electronic unit and a
Wankel rotary generator (using two-stroke fuel) weighing 390 kg. This was strapped to a simple 590 kg trailer that it could be operated from. Off the trailer the radar was 2.29 metres high with the antenna up, 1.07 metres with antenna folded, 1.7 metres wide and 1.5 metres long. The radar itself had a nominal 100 kW peak average output and a nominal pulse repetition frequency of 4000 pulses/second. The radar was connected by cable to the operator’s console (‘Indicator Azimuth Unit’) and connected to this was the ‘Mortar Coordinate Indicator’ that displayed the located mortar’s position to the detachment commander. The Foster scanner converted a narrow radar beam, about 40
mils diameter, into one 720 mils wide and 30 mils high. This beam had five pre-set operating positions determined by five different radar horns that directed the beam onto the antenna at slightly different angles. Two beam positions were used with a mortar bomb being recorded by the operator as it went through each beam. This gave two coordinates. The operator marked his screen at each bomb position and changed the beam angle. He then placed electronic crosshairs over his marks (which represented the bomb’s position in the horizontal plane) which the
analogue computer used to calculate the mortar coordinates using the expected mortar altitude that had been previously set. Setting-up the radar involved orientating it in a known azimuth (the basic mounting could cover an arc of 4800 mils) and setting the datum beam elevation between -90 and 360 mils so that it was above the
radar horizon. Other beam positions, 25, 40, 45, 65 and 90 mils were relative to this datum. The lowest beam position was used to alert the operator that a bomb was in flight and where to expect it on his screen; once alerted he tilted the beam into the first position, waited for it to appear, and then switched to the next angle. The angles were pre-selected according to the local circumstances. Data memory was also available, although in British service this was normally only fitted to Cymbeline Mk 2; in essence it recorded the detected mortar bomb signal and allowed it to be replayed. Cymbeline could locate a mortar with an accuracy of 50 metres. 81 mm mortars could be located at up to 10 km and larger mortars to 20 km. Secondary roles were area and coastal surveillance, helicopter and light aircraft control, meteor balloon tracking and rapid survey. It could also observe and adjust ground and airburst artillery fire and high angle fire. In British service each radar held a spare main electronic unit, spare generator and spare displays. The radar includes an integral simulator for operator training and practice and built-in test functionality. Cymbeline Mk 2 was mounted on an
FV432. The normal hatch covers over the rear compartment were replaced by a circular radar mounting, with three ‘supports’ for the radar turntable. The radar could be rotated up to 12 800 mils. Prototypes used hydraulic supports to level the radar but the production version used mercury in the same manner as Green Archer Mk 2 had. When the taps were opened and the radar unclamped the mercury levelled itself and the radar floated on it. There was some internal furniture for the operator and the displays, as well as racking for the spare assemblies, and a simple hoist to lift the assemblies up to the radar. For movement the antenna was lowered and the whole radar surrounded by a folding grille attached to decking around the radar to protect it. ==Operational history==